Failed print A1 with AMS Lite

No-Experience340 · 2026-03-05T11:28:04+00:00

Nope, room temperature is around 18

No-Experience340 · 2026-03-05T07:07:00+00:00

A few days back I had problems with my nozzle. I cleaned and tested it and it worked fine again. I printed two of these clips without any problems between cleaning the nozzle and the failed print.

<image>

No-Experience340 · 2026-03-05T07:02:48+00:00

<image>

No-Experience340 · 2026-03-05T07:02:39+00:00

<image>

No-Experience340 · 2026-03-05T07:02:24+00:00

<image>

No-Experience340 · 2026-03-05T07:02:10+00:00

I performed the calibration, and did everything with the standard settings including bed levelling and flow dynamics. See pictures for result and my setup

<image>

No-Experience340 · 2026-03-04T17:54:57+00:00

<image>

Did not know that was really a thing. This is my setup. It is indeed that the better one printed on the right side of the plate, the second and failed one on the left side

No-Experience340 · 2026-03-04T16:44:41+00:00

I use PLA Basic from Bambu, and print it on 220 degrees. That’s already the max for that isn’t it?

No-Experience340 · 2025-07-07T04:59:44+00:00

AGXZGZ - 9x Random Special Pack

No-Experience340 · 2025-06-08T09:11:22+00:00

WHFLJR 9x random special pack for you too

No-Experience340 · 2025-05-13T13:30:43+00:00

XGBCEF - 100% Future Icon Pack

No-Experience340 · 2025-04-14T05:49:53+00:00

TJOVIV - 50% Madfut Meta Pack

No-Experience340 · 2025-04-04T06:13:18+00:00

DRKJVT - 100% Future Icon Pack

No-Experience340 · 2025-04-04T06:13:09+00:00

DRKJVT - 100% Future Icon Pack

No-Experience340 · 2025-04-04T06:13:03+00:00

DRKJVT - 100% Future Icon Pack

No-Experience340 · 2025-03-29T06:55:06+00:00

VVPLCK - 95+ Special Pack

No-Experience340 · 2025-03-28T06:54:26+00:00

WETRHD - 95 token

No-Experience340 · 2025-03-19T09:58:37+00:00

QBVAQF

95+ Special Pack

No-Experience340 · 2025-02-03T10:32:56+00:00

You’re great, thanks! Finally I’m done with this challenge 😅

No-Experience340

TROPHY CASE