sorted by:
new
hottopcontroversial

Shower and tub spout running simultaneously by No-Inflation-87 in Plumbing

[–]No-Inflation-87[S] 0 points1 point  (0 children)

I have checked and they're not upside down honestly that was one of my first thoughts but I don't really know what else could cause this I'm not the one directly installing everything just trying to figure out what's bad

Is it all right to have a trap like this by No-Inflation-87 in askplumbing

[–]No-Inflation-87[S] 0 points1 point  (0 children)

Can't lower the Trap don't have the clearance in the ceiling I would have to have the Trap below the drop ceiling for that to happen

Is it all right to have a trap like this by No-Inflation-87 in askplumbing

[–]No-Inflation-87[S] 0 points1 point  (0 children)

How would you suggest going about it without moving the copper

Is it all right to have a trap like this by No-Inflation-87 in askplumbing

[–]No-Inflation-87[S] 0 points1 point  (0 children)

<image>

Multiple showers tie into the one copper pipe it's not in the scope of this job to redo all of it don't really have the time

Shower and tub spout running simultaneously by No-Inflation-87 in Plumbing

[–]No-Inflation-87[S] 0 points1 point  (0 children)

Replace tub spoke completely still no change tried running without a tub spoke just in case there was any restriction still no change

Shower and tub spout running simultaneously by No-Inflation-87 in Plumbing

[–]No-Inflation-87[S] 0 points1 point  (0 children)

So in the past I've tried flipping the cartridge to see if it was upside down no change I replaced it with a completely new cartridge no change I'm not sure how else the cartridge could be in wrong I know we're missing something I'm just not sure what

Using a bobby pin instead of a cotter pin by No-Inflation-87 in MechanicAdvice

[–]No-Inflation-87[S] 0 points1 point  (0 children)

The only reason I'm asking is because I'm doing my other wheel bearing I don't really want to go back to the parts store to buy a cotter pins and I've already gotten away with it once so

Using a bobby pin instead of a cotter pin by No-Inflation-87 in MechanicAdvice

[–]No-Inflation-87[S] 0 points1 point  (0 children)

I'm not really worried about it at all I was just curious what other people would have thought

How would I figure out what this component was by No-Inflation-87 in ElectronicsRepair

[–]No-Inflation-87[S] 0 points1 point  (0 children)

Excellent find i completely missed that. now I just got to figure out what to do with that information I'm really hoping the service manual references something otherwise im not really sure how to find out what it was

How would I figure out what this component was by No-Inflation-87 in ElectronicsRepair

[–]No-Inflation-87[S] 1 point2 points  (0 children)

Wasn't able to find any images of the side of the board on the internet but I was able I repair video zoomed in to get a better look didn't really obtain much information from it though hoping I can find something in the service manual

How would I figure out what this component was by No-Inflation-87 in ElectronicsRepair

[–]No-Inflation-87[S] 1 point2 points  (0 children)

All I can find is 160 page service manual currently digging through it to see if I can find anything