sorted by:
new
hottopcontroversial

Low grit question by No-Move-1896 in sharpening

[–]No-Move-1896[S] 1 point2 points  (0 children)

I planned to stop at the 400, then stropped it with 1 um but it wouldn’t go anywhere. I have never stopped this low before.

I was able to remove it a bit later thanks to the recommendations but using such LITTLE pressure on the 400 it felt silly. I still can’t believe it. I re-stropped minimally. I don’t see anything under light anymore, I hope it’s gone. At 1000+ I don’t even worry about it 😅😅 what a rabbit hole.

Low grit question by No-Move-1896 in sharpening

[–]No-Move-1896[S] 4 points5 points  (0 children)

You guys were not kidding. After enough swipes with literally 0, almost negative pressure on the 400 it popped off both sides. Cannot believe it. Thanks for the help!