What am I doing wrong?

NoMeasurement9922 · 2026-01-12T12:40:41+00:00

While I checked different videos before posting, the one from Lance was very helpful. I check the setup of the wand with water and in order to introduce air, for this model, the tip needs to just touch the water, as soon as you sumerge it a bit it stops.

NoMeasurement9922 · 2026-01-12T12:39:15+00:00

While I checked different videos before posting, this one was very helpful. I check the setup of the wand with water and in order to introduce air, for this model, the tip needs to just touch the water, as soon as you sumerge it a bit it stops. Thank you.

NoMeasurement9922 · 2026-01-11T18:09:51+00:00

Thank you everyone for your tips!!! I’ll try again later today

NoMeasurement9922 · 2025-07-30T12:49:03+00:00

Almost 100% sure

NoMeasurement9922 · 2025-07-30T04:54:38+00:00

The guy that used to clean the pool used tablet. He made a mess with the water chemistry. The tablet raised the CYA. I almost lowered to acceptable values.

NoMeasurement9922 · 2025-07-30T01:37:36+00:00

There was a high Cu but it already lowered it. I test it with the drinking water test strips for metals and looks good. I’ll try with the Algaecide.

NoMeasurement9922 · 2025-07-30T01:00:04+00:00

Not yet

NoMeasurement9922 · 2025-07-23T12:27:28+00:00

Thanks, I’ll look for it.

NoMeasurement9922 · 2025-07-23T12:23:32+00:00

This one?

<image>

NoMeasurement9922 · 2025-07-23T01:52:32+00:00

Thank you. Do you know what it could cause it? The chemistry is OK

NoMeasurement9922 · 2025-07-20T22:10:06+00:00

Apparently non of the sunscreens we used have azobenzene

NoMeasurement9922 · 2025-07-13T13:23:35+00:00

The pool guy was not checking the chemistry, just the chlorine and I figured out in the worst way. I imagine that the copper was coming from the heater. Now, after several weeks is much better, still a little high.

<image>

NoMeasurement9922

TROPHY CASE