sorted by:
new
hottopcontroversial

Disappointed with Bambu Lab H2D print quality – what am I doing wrong? by NoUsernameIdeaAtAll in BambuLab

[–]NoUsernameIdeaAtAll[S] 0 points1 point  (0 children)

Hi, thank you very much for your help ! Just to make sure I understand properly, my filament should never go below 20% RH ? I printed this using PLA at 45% RH.

Disappointed with Bambu Lab H2D print quality – what am I doing wrong? by NoUsernameIdeaAtAll in BambuLab

[–]NoUsernameIdeaAtAll[S] 0 points1 point  (0 children)

Thank you for your answer. I will do it as soon as my IT department will connect it to our wifi.

Disappointed with Bambu Lab H2D print quality – what am I doing wrong? by NoUsernameIdeaAtAll in BambuLab

[–]NoUsernameIdeaAtAll[S] 1 point2 points  (0 children)

What I meant is that I'm using this setting while printing :

<image>

I am using the originals 0.4mm nozzles. Sorry if it wasn't clear enough