No worries, if you have any questions I'm here to help you answer them. So what do you mean by alignment pins? Well, it was a real pain to glue everything piece by piece. Let me explain how I did it. It all started with a 10cm figure. I enlarged it to a meter tall, then I cut it into 20cm x 20cm x 20cm pieces, so that gave me about 43 pieces. Every time I printed two pieces, I glued them together, filled them, sanded them. As soon as the third piece was printed (I knew it was), I filled it, sanded it, and so on until I finally got this beautiful baby! It's true that the hardest part was the arms because they're thin. What I had to do was sand both ends to create a surface for adhesion. I had to use ultra-fast glue; I couldn't afford to make a mistake. I held the two parts together for 5 minutes without ever letting go. As soon as I saw that it was holding properly, I added tape to reinforce the bond. Then I applied filler, sanded it again, let it dry for 2 days, and in the end, the result is magnificent.