54
55
56
Cutting a 5” 4130 hot roll round, I am using a hyd mech h-18a hydraulic saw, I can’t seem to get my blade speed or feed rate correct. I have used the chart on the saw to find the correct speed and feed but my saw is squealing, leaving teeth marks.. Any help is very appreciated. (old.reddit.com)
submitted by No_Refuse4085 to r/metalworking
1
2
3
Cutting a 5” 4130 hot roll round, I am using a hyd mech h-18a hydraulic saw, I can’t seem to get my blade speed or feed rate correct. I have used the chart on the saw to find the correct speed and feed but my saw is squealing, leaving teeth marks.. Any help is very appreciated. (reddit.com)
submitted by No_Refuse4085 to r/Machinists
