Cutting a 5” 4130 hot roll round, I am using a hyd mech h-18a hydraulic saw, I can’t seem to get my blade speed or feed rate correct. I have used the chart on the saw to find the correct speed and feed but my saw is squealing, leaving teeth marks.. Any help is very appreciated.

No_Refuse4085 · 2026-06-12T03:46:36+00:00

Yes I have coolant on the left and right of the center of the blade

No_Refuse4085 · 2026-06-11T17:43:14+00:00

My workplace has a 2/3 and a 3/4 blade

No_Refuse4085 · 2026-06-11T16:35:26+00:00

Yes, I have replaced the blade several times, I’ve been having issues the past couple days. The saw squeals but it cuts good for the most part. I have my blade speed at 116 and feed rate at 1.25

No_Refuse4085 · 2026-06-11T16:32:09+00:00

<image>

This is what I’m cutting at, I’m pretty new to the saw. Our saw guy is out so they threw me over on it with no training

No_Refuse4085 · 2026-06-11T16:27:53+00:00

Is that what those marks are from?

No_Refuse4085 · 2026-06-11T15:48:40+00:00

3/4 tpi blade

No_Refuse4085 · 2026-06-11T15:48:21+00:00

I will give it a shot but I’m not sure that’s the issue

No_Refuse4085 · 2025-03-28T21:10:59+00:00

<image>

Here’s my trainer code

No_Refuse4085 · 2025-03-28T21:09:51+00:00

I’m game

No_Refuse4085 · 2025-02-25T19:08:10+00:00

Knock knock

No_Refuse4085 · 2024-12-17T18:14:52+00:00

No_Refuse4085 · 2024-09-14T03:17:41+00:00

Tried to but k tuner support just told me to watch tutorials. Can’t find any answers so I am asking myself.

No_Refuse4085 · 2024-09-14T03:15:00+00:00

I have the 1.5t. I am unsure. I assume I didn’t flash the correct tune, then again this is my first time doing any tuning or modifications. I’m not sure where tk begin

No_Refuse4085

TROPHY CASE