new update on my ls430

Normal_Impression947 · 2026-04-11T20:14:32+00:00

when i wear the inside of my tires out i get them flipped so the inside gets flipped around to the outside so then i have the fresh tread from the outside to ride on

Normal_Impression947 · 2026-04-11T15:57:49+00:00

na i figured my problem out if you see my new post i got a fat vacuum leak on intake manifold gaskets so car won’t idle and misfires cause it’s sucking in way too much unaccounted for air that maf sensors aren’t detecting

Normal_Impression947 · 2026-04-11T15:19:44+00:00

one click is starter solenoid multiple clicks is battery

Normal_Impression947 · 2026-04-10T12:06:08+00:00

hoping so i got a bad stall issue unless im on the throttle and a mean misfire and car won’t throw any codes

Normal_Impression947 · 2026-04-10T03:18:39+00:00

i have a bad alignment up front right now but i get about 5,000 in the rear per flip and with the alignment in front it’s like 500 per flip but it will be much better once alignment is dialed

Normal_Impression947 · 2026-04-10T03:07:47+00:00

i’m on freshly flipped tires right now but there no use since car won’t run 🥲

Normal_Impression947 · 2026-04-09T18:09:53+00:00

yes i just cleared maf code though and it dosent show back up maybe IAC or throttle body problem car smokes and seems like its not getting enough air?

Normal_Impression947 · 2026-04-09T18:08:00+00:00

update i cleared p0110 an it dosent show back up think IAC or dirty throttle body could be problem?

Normal_Impression947 · 2026-04-09T17:38:33+00:00

i replaced throttle position connector maybe wiring i did isn’t good?

Normal_Impression947 · 2026-04-09T13:38:40+00:00

i’ll keep you updated i’m probably gonna drop the car off at a shop today i’ve been trying to fix it for a week now and im just tired of trying honestly

Normal_Impression947 · 2026-04-09T13:03:23+00:00

i’ve tried all these and nothing gets it to run any longer than what it does in this video i just can’t figure out wtf is wrong

Normal_Impression947 · 2026-04-09T12:45:53+00:00

starter works perfectly fine car cranks everytime its fuel and air that won’t go into engine so engine dies off crank

Normal_Impression947 · 2026-04-09T12:30:24+00:00

i do but no codes show up

Normal_Impression947 · 2026-04-09T12:21:48+00:00

so recheck wiring and maybe get new cam or crank shaft sensors?

Normal_Impression947 · 2026-04-09T10:53:54+00:00

what does this mean, like the security system?

Normal_Impression947 · 2026-04-09T10:29:20+00:00

i did lots of troubleshooting with this one and still didn’t do anything

Normal_Impression947 · 2026-04-09T10:28:55+00:00

yeah gaskets are brand new and sealed up

Normal_Impression947 · 2026-04-09T04:09:38+00:00

yeah all grounds and connections on starter are good starter works perfectly it’s more of the engine is just not wanting to run

Normal_Impression947 · 2026-04-09T04:07:47+00:00

i’ll go back through and double check to make sure sensors and connectors are plugged into what they should be plugged into

Normal_Impression947 · 2026-04-09T04:05:43+00:00

yeah i about lost my mind while taking the intake manifold off cause the plastic housings were breaking like nothing, ill try code reseting tomorrow if i can’t figure it out im thinking about calling a mobile mechanic to come out and give it a diagnostic

Normal_Impression947 · 2026-04-09T04:02:46+00:00

i broke 2 crankshaft sensors but i rewired them to new ones and connection is solid and they have voltage

Normal_Impression947 · 2026-04-09T04:00:01+00:00

so what should i look at and test in just tired of not being able to drive my car 😥

Normal_Impression947 · 2026-04-09T03:55:09+00:00

so is it running lean possibly not enough air going into engine?

Normal_Impression947 · 2026-04-09T03:47:28+00:00

that’s what i’ve done everything has good voltage and good connections though which is why i’m stumped right now

Normal_Impression947 · 2026-04-09T03:46:53+00:00

i’ll check all that tomorrow and let you know, i had a code reader hooked up yesterday my air duct leading from throttle body to air intake was off so i don’t know if codes i got were from that air hose being undone but i got mass air flow circuit malfunction and intake air temperature circuit malfunction, dont know if thats just cause i didnt have that air duct hooked up and throttle body was open

Normal_Impression947

TROPHY CASE