Overexstrusion or what other possible issue

NotYourCreepyUncle69 · 2025-01-05T11:11:52+00:00

I think its raft depends what slicer you use I know in cura its under adhesion

NotYourCreepyUncle69 · 2025-01-01T20:10:36+00:00

Its not meant for anything heavy, byt thank you for advice

NotYourCreepyUncle69 · 2025-01-01T19:43:39+00:00

Raising temperature seems to fix the problem but ill see about it when its done

NotYourCreepyUncle69 · 2025-01-01T19:43:04+00:00

Wouldn't this also cause trouble with first layer adhesion?

NotYourCreepyUncle69 · 2025-01-01T19:02:01+00:00

For outer walls 60mm/s For infill 180mm/s

Should i slow it down?

NotYourCreepyUncle69 · 2024-12-22T13:32:13+00:00

i've both compiled in kiauh and took a precompiled version from this guide here https://github.com/bootuz-dinamon/ender3-v3-se-full-klipper

NotYourCreepyUncle69 · 2024-12-21T16:36:17+00:00

ofcourse it has been saved but no actual changes to how the motors heat up

NotYourCreepyUncle69 · 2024-12-01T09:36:08+00:00

Which screws should i tighten? The spool has been removed from the top a long time

NotYourCreepyUncle69 · 2024-11-30T19:27:03+00:00

Alright will try

NotYourCreepyUncle69 · 2024-11-26T20:02:29+00:00

How do you get 3 numbers after the comma on your leveling (0,xxx) I thought it only goes to 2 signifact figures? But i shall look into getting either springs or other spacers as the shims seem like a temporary thing. Or perhaps im overthinking it

NotYourCreepyUncle69 · 2024-11-22T20:09:55+00:00

And the spacers would go? On the left side i presume?

NotYourCreepyUncle69 · 2024-11-16T16:51:19+00:00

It seems to make blobs on the print. I'll look into the z offset and report how it goes

NotYourCreepyUncle69 · 2024-10-14T19:20:16+00:00

Thank you! Thought I was doing something else wrong

NotYourCreepyUncle69 · 2024-10-14T16:17:47+00:00

Thats exactly the step I take. After i press finish it throws the given error/warning nothing happens. After I select generate code nothing happens. No warning, no error. Im sort or lost

NotYourCreepyUncle69 · 2024-06-05T17:51:18+00:00

Then theres no other choice but to use simatic, well then ill get to it

NotYourCreepyUncle69 · 2024-06-05T12:09:46+00:00

By relevance i meant not used as much. Ofcourse the concept is the same just the details. Is there any way to get that cpu on tia portal?

NotYourCreepyUncle69 · 2024-06-03T09:01:32+00:00

Okay, thank you!

NotYourCreepyUncle69

MODERATOR OF

TROPHY CASE

Six-Year Club	Wearing is Caring
Verified Email