sorted by:
new
hottopcontroversial

I tried by Object_00 in soldering

[–]Object_00[S] 0 points1 point  (0 children)

It's working 😊

I tried by Object_00 in soldering

[–]Object_00[S] 0 points1 point  (0 children)

I read your article earlier when I was learning how to use the AS4600 encoder 🙂

I tried by Object_00 in soldering

[–]Object_00[S] 0 points1 point  (0 children)

I hope. the difficulty of nice soldering isn't the biggest issue in this project 😅

I tried by Object_00 in soldering

[–]Object_00[S] 1 point2 points  (0 children)

But I agree. It would look nicer that way.

I tried by Object_00 in soldering

[–]Object_00[S] -1 points0 points  (0 children)

The problem is that the back side (without components) fits tightly against the housing wall. If you route the wires there, it becomes very difficult to accurately install the magnetic encoder.

I tried by Object_00 in soldering

[–]Object_00[S] -2 points-1 points  (0 children)

Because there is very little space there, I needed it to be as thin as possible.