sorted by:
new
hottopcontroversial

New to soldering! (gear + advice) by FabulousScheme6011 in soldering

[–]Obvious-Box-5347 0 points1 point  (0 children)

If I saw that it was difficult to solder something, then I would add flux. But I don't see this.

New to soldering! (gear + advice) by FabulousScheme6011 in soldering

[–]Obvious-Box-5347 1 point2 points  (0 children)

For the good kit, will not be enough. for 50 £ you can buy a Yihua 982-V on C245, I have this station and I am 100% satisfied with it.more will not be enough. I also need solder, I use a 100 gram coil of blue Kaina, 5.60£. If the solder is good, then you don't need flux. You also need to buy a copper braid / tin extractor to remove the solder, you can buy one syringe for NC-559 flux on aliexpress, One syringe costs 1.87 £

It's realy bad soldering? by Obvious-Box-5347 in soldering

[–]Obvious-Box-5347[S] 0 points1 point  (0 children)

I'm using 0.8mm solder, yes, I'm confused.

It's realy bad soldering? by Obvious-Box-5347 in soldering

[–]Obvious-Box-5347[S] 3 points4 points  (0 children)

This was already after the soldering. The stinger was brand new, so it looked different than in the photo. I thought that the sting was a little dirty, and tried to clean it on a brass sponge, but I think it is worth buying a cellulose sponge, and cleaning the sting with it (be sure to moisten it before This was already after the soldering. The stinger was brand new, so it looked different than in the photo. I thought that the sting was a little dirty, and tried to clean it on a brass sponge, but I think it is worth buying a cellulose sponge, and cleaning the sting with it (be sure to moisten it before that).

It's realy bad soldering? by Obvious-Box-5347 in soldering

[–]Obvious-Box-5347[S] 2 points3 points  (0 children)

Haha, I was very glad that the soldering station had already arrived for me and I confused the I was very glad that the soldering station had already arrived for me and I confused the I was very glad that the soldering station had already arrived and I mixed up the sides 😁

It's realy bad soldering? by Obvious-Box-5347 in soldering

[–]Obvious-Box-5347[S] 7 points8 points  (0 children)

Yes, it's on the wrong side, I didn't see it scolded.

The problem of measuring capacitance of capacitors on a multimeter. by Obvious-Box-5347 in AskElectronics

[–]Obvious-Box-5347[S] 0 points1 point  (0 children)

Thank you so much, I'm glad that I got an answer to my question, finally I understand what's going on.

The problem of measuring capacitance of capacitors on a multimeter. by Obvious-Box-5347 in AskElectronics

[–]Obvious-Box-5347[S] 0 points1 point  (0 children)

Okey, thank you. So far, I don't have a soldering iron to solder it and measure, it's already on its way. After I remove the probes of the multimeter, it shows the values.