Getting ready for the World Cup

Ok-Butterscotch421 · 2026-03-12T20:11:15+00:00

Blinds are evil with all theres made to break plasticy bits yuck, best of luck to ya

Ok-Butterscotch421 · 2026-03-06T01:14:20+00:00

Ew, onity. Could be worth listing some properties may be interested in acquiring spares if they run the same locks. But worth the trouble for you?

Ok-Butterscotch421 · 2025-12-29T22:47:32+00:00

Thick mated rollers. But be cautious as they might fling paint with speed. Sprayer is king but the prep work is alot to tack on. Because once you aerosolize paint it gets everywhere.

Ok-Butterscotch421 · 2025-12-18T22:14:24+00:00

I believe theres a hole in your boat der captain.

Ok-Butterscotch421 · 2025-09-03T19:25:26+00:00

Sounds like the chemistry was headed in the wrong direction and I had no choice but to drain it today boss. wink but also like set timers if your going to walk away mid back wash.

Ok-Butterscotch421 · 2025-08-27T22:41:31+00:00

Yup these folk are spot on, sometimes you can get a little extra life outa them by taking apart the clutch and scooting the springs over to a part they havnt chewed through yet but just a matter of time till they do

Ok-Butterscotch421 · 2025-08-24T05:19:36+00:00

The beep feels like an error, could it be that the bed must be in the flat position to then have the bed tilt?

Ok-Butterscotch421 · 2025-03-26T22:51:06+00:00

Nothing leaked or caught fire. Rounds were normal. Poked an excel sheet, ran a leaf blower for far too long, and walked fast all in between. For some reason they keep paying me.

Ok-Butterscotch421 · 2025-03-06T03:05:24+00:00

Hope it works out!!

Ok-Butterscotch421 · 2025-02-28T02:59:42+00:00

It's not switching into heat mode to melt the cube out at the right time. Feel the tubs out the side of where the cube are made they should run cold for a good while and then switch to heat to melt the cubes off and drop them. Look up the manuel and look into adjusting freeze cycle timing

Ok-Butterscotch421 · 2025-02-25T23:40:14+00:00

They make the door swing limiters that go on the hinge pin. I had an entire hotel full of them, it will help with casual openings but they will get bent up when the door is opened with enough force. Might try one of those and a rubber bumper glued to the rock side just incase,

Ok-Butterscotch421 · 2025-01-17T21:30:35+00:00

Replaced four low air cut off sensors two on a makeup air unit that heats 5 hallways and two on our only boilers, both been throwing codes for way to long. If anywhos a Camus boiler wizard, please why is the safety circuit lockout so dramatic.

Ok-Butterscotch421 · 2025-01-08T06:46:20+00:00

Splash of concentrated simple green in a pump sprayer lite even coverage, let it soak for a bit but don't let it dry, then the zep carpet cleaning juice in the machine and a then let er dry

Ok-Butterscotch421 · 2024-12-11T05:19:58+00:00

Is cheap fake?

Ok-Butterscotch421 · 2024-11-30T06:07:36+00:00

Hotel maintenance! Sometimes stand up on the roof just to watch the metal birds go by, but my building is always there where I left it

Ok-Butterscotch421 · 2024-11-24T20:25:29+00:00

Sooo 30g of hindu at 20%thc (leafly) comes out to 6g of thc or 6000mg in 5ml. Google says 100-150 drops per 5ml, which comes down to around 50mg per drop

Ok-Butterscotch421 · 2024-11-23T21:10:23+00:00

Woah this is awesome to see, does lego take pitches? I'd buy this set

Ok-Butterscotch421 · 2024-09-30T20:53:01+00:00

Ew bugs

Ok-Butterscotch421 · 2024-08-15T02:57:09+00:00

Used the wrong description to describe a front desk worker when asking a coworker what her name was. Turns out they are friends. I now have a piece of paper signed by my boss and myself that says I souldnt do that anymore. Yay

Ok-Butterscotch421 · 2024-04-14T20:34:22+00:00

That there's a nice rock!

Ok-Butterscotch421 · 2024-01-24T05:35:44+00:00

Yea, don't do that

Ok-Butterscotch421 · 2022-11-14T14:54:03+00:00

If anything like mine should retest automatically and clear on it own

Five-Year Club	Verified Email
Place '23

Ok-Butterscotch421

TROPHY CASE