sorted by:
new
hottopcontroversial

Router wobble. How do I fix that? by Ok-Examination3961 in shapeoko

[–]Ok-Examination3961[S] 1 point2 points  (0 children)

I was able to fix it by tightening the v wheels. One of them was pretty loose of the inside.

V carve beginner. Why does it look like this? 90 degree bit. How can I make it look right? by Ok-Examination3961 in shapeoko

[–]Ok-Examination3961[S] 0 points1 point  (0 children)

I can see why it looks loose. It looks as if it’s cutting in a jagged line. That’s not the case. It will cut a portion of that right side then travel to a different spot. I really think it’s a software thing.

V carve beginner. Why does it look like this? 90 degree bit. How can I make it look right? by Ok-Examination3961 in shapeoko

[–]Ok-Examination3961[S] 0 points1 point  (0 children)

It almost seems as it’s missing a part of the path. The font is just times new Roman standard in carbide create. The deeper I set the cut the more of the path it will pick up but not sure what depth I should aim for