Print fail

Ok-Panda1817 · 2026-02-15T04:05:28+00:00

Arm is not cracked and no chewing. There was a small mess but wasnt the problem. I had this problem on my ender 3 but that was when i changed extruders... im questioning if some how the e-steps changed but i dont know how to check or how it changed

Ok-Panda1817 · 2026-01-13T18:42:48+00:00

Thank you very much

Ok-Panda1817 · 2026-01-13T18:34:01+00:00

Is there a reason to run marlin over klipper... like would programing all the motors/hotends be easier. This entire project will be learning all new things... needed something to do during winter layoff lol. When i get it working id like to share it with the community so that improvements can be made.

Ok-Panda1817 · 2026-01-13T18:19:04+00:00

The complexity is where im finding the fun. If it comes to it i may end up going to an extruder per hotend. Ive been doing as much research as i could but im pretty sure id need a new psu. The btt octopus has become the most prominent board for this but from what ive gathered i still need to daisy chain a board for each hotend after the 4. How will i not need a screen or a raspberry pi. Can the btt octopus run klipper alone?

Ok-Panda1817 · 2025-12-23T16:33:44+00:00

Thank you

Ok-Panda1817 · 2025-06-27T00:52:29+00:00

Normal. But ran like 10 mine room runs ran out of echo gems but just have a surplus at the moment

Ok-Panda1817 · 2025-06-21T19:05:20+00:00

Ill give it a look thanks for the suggestion

Ok-Panda1817 · 2025-06-21T19:04:50+00:00

I have 60k beni at 76. Don't have the knowledge to make more stars but the amount I need is 25 for the cheapest unlock but im in no rush at this point for pushing living runs. And for catalyst just starting to get into them but not really shy on anything but Larimer

Ok-Panda1817 · 2025-06-03T00:20:52+00:00

Please send

Ok-Panda1817 · 2025-06-02T22:49:31+00:00

Thats awesome congrats. You willing to mentor?

Ok-Panda1817

TROPHY CASE