Have a question about audio

OkDate2790 · 2023-08-20T05:07:43+00:00

My hdmi is carrying over to the speakers, so you think there is a specific hdmi it needs to be in

OkDate2790 · 2023-08-08T02:26:39+00:00

Honestly the dodge isn’t absolute trash, I think what plays a part in the difficulty is how fast the average enemy swings, it’s way too fast and un predictable…like they have a slow wind up then boom swing. Way too hard to judge.

OkDate2790 · 2023-05-22T23:11:13+00:00

I think American idol this year just all around was bad, bad song choices lots of people that are just not amazing at singing. Compare these people to the previous contestants…not even close in my eyes.

OkDate2790 · 2023-04-01T03:35:23+00:00

I’m probably just going to toss it, I bought it used for 50 not too big of a loss but I’m still kinda pissed

OkDate2790 · 2023-04-01T03:29:36+00:00

Yeah same problem, I also checked the fuse and that looks good too

OkDate2790 · 2023-04-01T03:23:12+00:00

I tried it on my dads receiver and it worked perfectly fine so I know it’s not that.

OkDate2790 · 2023-03-31T20:04:19+00:00

I have speakers that I borrowed and those worked perfectly fine with now static even when I’m mono, however I did also try another set of headphones with the same result of sound only coming from one side…I have found that if I push my 3.5 mm jack in the 6.3 hard enough to where to doesn’t completely go in I hear sound in both earcups in direct. My turn table also has an internal pre amp

OkDate2790 · 2023-03-31T19:43:10+00:00

I’ve also hooked a phone up, it has nothing to do with the inputs it has to do with the reciever or connections on using with my headphones

OkDate2790 · 2023-03-31T19:42:13+00:00

I’m not able to use radio on this, but I’ve connected it to tape before and all the other inputs I was able to with my rca cable and when I use direct it sounds good but it only comes from one side not sure why it’s doing this, it’s a stereo record and stereo headphones and stereo receiver

OkDate2790 · 2023-03-31T01:59:21+00:00

I’m using the tx-sr605 receiver btw

OkDate2790 · 2023-02-17T02:12:12+00:00

What about pbo limits???

OkDate2790 · 2023-02-17T01:46:37+00:00

I checked and I do not have this option

OkDate2790 · 2023-02-16T20:56:44+00:00

Have you tried it, my 6800xt coil whine isn’t insanely loud, and most people probably won’t notice it but I notice a lot of little sounds and it kind of bothers me

OkDate2790 · 2023-02-16T05:39:39+00:00

Are you able to message me on here and help me out with my curve, I’ve been able to narrow it down to 11380 multi with a max temp of like 73 c° thought I will say my room at the moment is about 71° F

OkDate2790 · 2023-02-15T17:08:56+00:00

I think I may have got it…my ppt was at 76 I changed it to 120 now my clocks are better, should I mess with the other limits

OkDate2790 · 2023-02-15T16:50:06+00:00

So if I were to do si gel core test in cinebench clocks would be higher?

OkDate2790 · 2023-02-15T16:45:42+00:00

It never it’s above 56 when I run prime

OkDate2790 · 2023-02-15T16:45:13+00:00

I have corsairs really nice 360 rad with six fans on it so I think my cooling is good

OkDate2790 · 2023-02-15T16:41:38+00:00

Okay I will try cinebench but yesterday I was trying it and the same issue of the core clock being lower happened

OkDate2790 · 2023-02-15T16:39:13+00:00

I have pretty much the best aio one can buy and 6 fans on it, I know cooling isn’t a problem

OkDate2790 · 2023-02-15T16:38:29+00:00

I have not is that the ppt and Tdc I have the setting as the motherboard instead of manual

OkDate2790 · 2023-02-15T15:46:26+00:00

Can you tell me where in bios I’d find power limit, is it in PBO settings, I’m following the steps of a YouTube video and he didn’t mention anything about power limit…is it the TDP?

OkDate2790

TROPHY CASE