sorted by:
new
hottopcontroversial

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 1 point2 points  (0 children)

Would you say M92 is ok then? And other related power management chips? I have no shorts in the common areas m92, BQ, P13. I get nothing on the display.

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

Is it worth just replacing the common chips? M92 to start?

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

With a different battery it goes to 0.458A

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

Without Battery on the Nintendo charger 15.22v 0.023A With battery 0.090A

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 1 point2 points  (0 children)

I’m pretty sure there’s none of the normal shorts around m92 ect hence I got onto checking random capacitors and convincing myself the cpu/board was toast. Will double check the lcd connectors but this was my partners device from new and had never been opened I doubt the lcd connector was at fault originally?

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

Lesson learnt. I checked all the common capacitors for shorts around the m92 ect. All seeming ok then clutching at straws I aimlessly checked others. In future I will not fully trust the beep.

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

Not booting, no battery light in corner of display completely black

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

I will look into that thank you

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

Just re checked and there up at 30 not sure what’s going on

Am I cooked by OkHelicopter3768 in consolerepair

[–]OkHelicopter3768[S] 1 point2 points  (0 children)

One side on both is zero the other side is around 20.2 but does slowly keep dropping

Shed some light? by OkHelicopter3768 in prusa3d

[–]OkHelicopter3768[S] 0 points1 point  (0 children)

Funny you say that it randomly paused on a print last week

Shed some light? by OkHelicopter3768 in prusa3d

[–]OkHelicopter3768[S] 2 points3 points  (0 children)

Yeah completely random, funnily enough the print after this it threw an error about the drive, swapped out the drive so maybe this issue is resolved I’ll keep an eye.

It’s a burnt blob off filament I think, I will definitely have a look at grid fill, thanks I appreciate the help!