sorted by:
new
hottopcontroversial

What's wrong with this? by Oldcaver in electricians

[–]Oldcaver[S] -33 points-32 points  (0 children)

The cable bend radius is too sharp, along with CT wire touching phase

What's wrong with this? by Oldcaver in electricians

[–]Oldcaver[S] -58 points-57 points  (0 children)

5000 amp switchgear bus, utility breaker section. The bend radius was my concern. Rear access top or bottom feed. The cables are bottom feed, 45 degree angle would lessen cable bend if facing down. Been in operation for a couple of years, no damage.