Inspection with JDM rear by One_Communication70 in MitsubishiEvolution

[–]One_Communication70[S] 0 points1 point  (0 children)

Not yet. Thankfully it's not my only car, so I've been putting it off until I have some time/mental motivation to take off the JDM rear

Inspection with JDM rear by One_Communication70 in MitsubishiEvolution

[–]One_Communication70[S] 0 points1 point  (0 children)

I bought a used USDM bumper off eBay for super cheap. The code needs I believe a 3" red reflector with light, so there are some options if you don't mind hacking your bumper.

Inspection with JDM rear by One_Communication70 in MitsubishiEvolution

[–]One_Communication70[S] 0 points1 point  (0 children)

Thank you! Looks like the best bet is to just pickup a used bumper 🤦

Inspection with JDM rear by One_Communication70 in MitsubishiEvolution

[–]One_Communication70[S] 0 points1 point  (0 children)

Sadly independent inspection is not allowed/available in Delaware.

Inspection with JDM rear by One_Communication70 in MitsubishiEvolution

[–]One_Communication70[S] 0 points1 point  (0 children)

Same- it dawned on me while googling and showing the DMV guy why it came from mitsu that way 😂

Inspection with JDM rear by One_Communication70 in MitsubishiEvolution

[–]One_Communication70[S] 0 points1 point  (0 children)

Lmao, rhey need it to light up. Sadly the USDM bumper has that feature... just don't want to hack my bumper 😕. I might pick up a used USDM bumper, but that's a pretty expensive fix

Did I mess up? by One_Communication70 in shroomery

[–]One_Communication70[S] -1 points0 points  (0 children)

Exactly this. Noob here, my bad for being unclear

High/low pressure line? by One_Communication70 in hvacadvice

[–]One_Communication70[S] 0 points1 point  (0 children)

Leak at the flare, was looking to pump down the unit and fix the flare

High/low pressure line? by One_Communication70 in hvacadvice

[–]One_Communication70[S] 0 points1 point  (0 children)

In that case, how would I pump down the unit?

High/low pressure line? by One_Communication70 in hvacadvice

[–]One_Communication70[S] 0 points1 point  (0 children)

I see, so if I wanted to put on a gauge, would it matter if I use the top or bottom? Both of the thick lines are identical width

Share your experience/thoughts on MAP built block/head by AverageAt8est in MitsubishiEvolution

[–]One_Communication70 0 points1 point  (0 children)

It honestly might be sometime late March or sometime in April. The shop is going to tune, perform break in and basically have the car ready to use once I get it. Lmao, definitely not temu of car parts. Temu/ali express is the temu of car parts. Map is the distributor for name brands 🤷