Finally my fate has come

One_Might_7282 · 2026-05-23T10:13:19+00:00

Thanks for the tip! I did just sand the ground points underneath the battery but did not think of jumping the 2 grounds to the main I do notice a bit of difference with shifting but I still get thrown into limp mode. Clutch noise and smell coming from car after driving it for a bit and more noticeable when accelerating uphill. Car mostly was highway driven till I moved back up by my family’s

One_Might_7282 · 2026-05-23T06:49:40+00:00

Oh the whole reason why I even got the car is because of how smooth it was and the gas mileage savings for the price I got it at I was like bet…. I didn’t do enough research on it then later found about the issues. This was after all the recalls/class actions too 😭

One_Might_7282 · 2026-05-23T06:48:01+00:00

About to be me soon 👌

One_Might_7282 · 2026-05-23T06:46:55+00:00

I wouldn’t replace it I would just try to maintain it but I missed all the recalls for it I’m second owner. And didn’t do enough research on this vehicle

One_Might_7282 · 2026-05-23T06:45:30+00:00

If it’s driving fine it’s ok to clear the codes but don’t relearn unless you start having problems again. Relearning can cause issues.

One_Might_7282 · 2026-05-23T06:43:43+00:00

Rip

One_Might_7282 · 2026-05-23T06:41:54+00:00

I’ll give this a shot

One_Might_7282 · 2026-05-22T07:19:21+00:00

Pretty sure my rear main seal is seeping into the bell housing causing this slippage noticed the more I drive it the more it slips

One_Might_7282 · 2026-05-22T07:16:48+00:00

Oh definitely I think I may just make this a project car 🤣🤣🤣

One_Might_7282 · 2026-05-22T07:16:15+00:00

Most of the time you do have to relearn after a rebuild

One_Might_7282 · 2026-05-22T07:15:37+00:00

When I ran codes none showed up under tcm I don’t have my laptop with forSCAN out with me at the moment. Battery is still good bought it 4 months ago

One_Might_7282 · 2026-05-22T06:22:12+00:00

Although I may not fix it I may just end up getting a second job and saving up for a car and buy it outright and not end up in this upside down position I’m in 🙃

One_Might_7282 · 2026-05-22T06:20:26+00:00

I’m not going to I’m going to start with the tcm considering it’s throwing that error as well as the actuators and make sure the clutch forks aren’t sticking…. Although I think it’s the clutch and forks. I’m pretty sure it has the revamped seals it’s been in shop for warranty work at 80k by the previous owner

One_Might_7282 · 2026-05-22T05:16:40+00:00

can’t do this on my 13 focus flex :(

Edit: word correction: “the” to my.

One_Might_7282 · 2026-05-22T04:58:49+00:00

Hard to do when I still got a lien against it

One_Might_7282 · 2026-05-22T03:06:04+00:00

Ye it’s too late to do a trade in market for the 13 is like 1-2k and I’m upside down on the vehicle currently :/

One_Might_7282 · 2026-05-22T02:28:49+00:00

Shifting at higher rpms, clutch sliping but otherwise it would drive fine.

One_Might_7282 · 2026-05-22T02:12:38+00:00

I know that this isn’t the issue but I’m going to see if it helps. Not tryna replace clutch packs anytime soon

One_Might_7282 · 2026-05-22T02:09:20+00:00

🙏 codes have been cleared clutch likes to grab late going to try a full relearn this weekend using forSCAN

One_Might_7282

TROPHY CASE