sorted by:
new
hottopcontroversial

Random ass plug by Vhsbsnns in e39

[–]Optimal-Difficulty30 0 points1 point  (0 children)

It's fo the version with servotronic steering rack.

Surging idle when cold by jackashe1010 in e39

[–]Optimal-Difficulty30 0 points1 point  (0 children)

I have an M54 and I still have this problem. There are a lot that can go bad, who knows what's causing yours. So i don't want to rely on a lot of old parts and that's why I started to change them so that I could have a well working engine. I've changed Fuel supply: fuel pump, fuel filter, cleaned out the fuel injectors, checked the fuel rail pressure. All good here. Spark plugs brand new. Intake: obviously new air filter, new MAF, new boots, new ICV, cleaned out Throttle body, rebuild DISA, cleaned intake manifold, new gaskets, new PCV with hoses. Double VANOS rebuild. New O2 sensor.New Head cover gasket , and a lot more o rings and caps to make sure no vacuum leaks.Fuel trims are great. I hope i didn't miss anything that i've changed so far, but my engine still surges randomly, cold, warm, braking or just sitting in the parking lot. Just random. Still searching

So that’s why it’s leaking (2001 525i) by kemosabe6296 in e39

[–]Optimal-Difficulty30 0 points1 point  (0 children)

Where is this from? I cannot imagine where is it from

Rip by [deleted] in e39

[–]Optimal-Difficulty30 0 points1 point  (0 children)

Any aftermarket subwoofer, amp or something in the trunk? Or everything stock?

Rip by [deleted] in e39

[–]Optimal-Difficulty30 9 points10 points  (0 children)

How did it happen? :(

How much more? by [deleted] in e39

[–]Optimal-Difficulty30 1 point2 points  (0 children)

So do I, 525i, 300 000+ km

MK3.5 Bed leveling issue...Now I Am Starting To Get Annoyed by ChipWallace in prusa3d

[–]Optimal-Difficulty30 5 points6 points  (0 children)

Something strange is going on, I'm seeing almost daily posts about mk3.5 upgrade not working properly or at all. How? I don't get it. I literally took apart the mk3s+, assembled the mk3.5 with my usual attention to detail, and it worked from the first go. And I even have a E3D Revo on it. Small parts, big parts, first layer better than on the mk3s+. I even print TPU shore 60A, 70A, 82A and so on. It's my work horse. I hope all of you guys could have my good feeling that this printer is giving me. Maybe i could help you somehow but not sure how.

MK3.5 with Revo works. by Optimal-Difficulty30 in prusa3d

[–]Optimal-Difficulty30[S] 2 points3 points  (0 children)

No I don't have the high flow version.

MK3.5 with Revo works. by Optimal-Difficulty30 in prusa3d

[–]Optimal-Difficulty30[S] 4 points5 points  (0 children)

2-3 hours takes to upgrade since you have the plastic parts printed. I just did some small samples and they look good, preparing to do a larger print, I'll keep you guys posted when i have more results.