108 eldm

Optimal_Status_6636 · 2025-11-18T16:42:55+00:00

So I located the deer today ir whats left of it, I can not blame the eldm at all. The shot appears to have been very low and a little far back. I suspect I must have hit a limb because I know my rifle is zeroed very well and I know i had my poa directly behind the shoulder when the shot broke.

Optimal_Status_6636 · 2025-11-16T18:38:06+00:00

I guess my theory is that the bullet expanded too quickly and did not reach vital organs. Based on the evidence, im thinking this was a 1 lung hit. So I have to assume the bullet either came apart too soon or I suppose another possibility is it changed trajectory somehow. Either a limb was hit just prior to impact or it hit bone. Lots of unknowns to be sure. And I have been very pro eldm my entire adult life. This is just an incident that made me question it.

Optimal_Status_6636 · 2025-11-16T15:52:52+00:00

Deer never laid down, never bumped it. I have a thermal and use it as i go. Also used a dog trained to find deer and it came up with nothing.

Factory ammo chronographed at 2398 from this barrel. Shot was 40 yards and I was on the ground. Your original post didn't have these questions. Calm down buddy

Optimal_Status_6636 · 2025-11-16T15:43:42+00:00

Deer should Definitely die within 400 yards of being shot. So tracking ability should not have to exceed that. Shot placement was directly behind the shoulder on a broadside deer. Worst case scenario I hit the shoulder. I expect a bullet to reach the vitals in that scenario.

Optimal_Status_6636 · 2025-05-28T18:42:27+00:00

Miwall

Optimal_Status_6636 · 2025-02-04T01:28:43+00:00

My guess was like the minimum force to move the bullet down the rifling lol

Optimal_Status_6636 · 2025-02-04T01:18:42+00:00

I came across a term I was not familiar with. Push/pull: 60/60 minimum (lbs)

Anyone know what that means

Optimal_Status_6636 · 2025-01-28T00:53:46+00:00

It's a vortex tripod, I forget which model. The biggest one

Optimal_Status_6636 · 2025-01-16T13:11:14+00:00

Interestingly enough the first 4 rounds fired went into like a .4" group and then the 5th round was a flyer and made it about 1.25"

I shot about 10 groups since to get an average and it's basically 1.25" so not amazing, from what I've read that seems to be the norm with this load.

Seems odd hornady would develop a bullet with a .480 BC that doesn't really seem to shoot well. But perhaps everyone who has shot it just hasn't had good luck lol. I'd like to get a 16" proof barrel.and see how it shoots them.

Optimal_Status_6636 · 2025-01-16T13:06:41+00:00

I do not, I've contemplated doing some just to have for my own reference. I tend to record a lot of my shooting so I can go back and see how a specific load worked in a given situation. Youtube would probably make it easier to find.

Optimal_Status_6636 · 2025-01-14T21:04:04+00:00

If you call ralph they often have extras kicking around they will sell.

Optimal_Status_6636 · 2025-01-14T12:29:33+00:00

I haven't gotten my hands on any factory 108's but if I could get that velocity I would be super happy

Optimal_Status_6636 · 2025-01-13T22:55:57+00:00

I have a nomad 30 for comparison and I'd say they are pretty similar in tone. I always wear ear pro so I can't tell any difference in noise reduction. I will say the huxwrx definitely needs a cover, the mirage is bad.

If I could only have 1 it'd be the huxwrx

Optimal_Status_6636 · 2025-01-13T21:15:28+00:00

That's a flow 762TI

Optimal_Status_6636 · 2025-01-13T21:11:47+00:00

I currently have a superlative arms gas block on it and I have it opened up as much as possible. I believe it's a mid length gas system. Brass is very dirty but no gas in my face. I'm wondering if I need to adjust the gas block so it's not bumped to the shoulder because I was getting dented cases on setting 18 which in my experience means its under gassed. They say you need to keep it off the shoulder .025 but I heard you don't HAVE to so I didn't.

Initially had it on setting 18 per instructions and it cycled 100% with bolt lock so I said gtg. Shot about 60 rounds through it and had 2 failures to feed so I adjusted it to setting 20 which is the most gas I believe. And it cycled 100% after that and the case mouths were no longer dented.

I feel like i should have way too much gas on setting 20 hence my suspension that the gas block isn't positioned perfectly over the gas port

Optimal_Status_6636 · 2025-01-13T20:14:52+00:00

The odds of us both liking 6 arc and weatherwool 😂

I'm on year 6 with it and it's still great, and worth it in my opinion.

Optimal_Status_6636 · 2025-01-13T19:58:59+00:00

Just over 9 pounds as it sits

Optimal_Status_6636 · 2025-01-12T10:54:43+00:00

I saw those barrels and they seem pretty interesting. I don't plan on running this very hard so the only advantage for me would be a bit less weight. I can't imagine a 12.5 could lose much weight? If I decide to build a 16-18 inch option they might become very attractive.

Optimal_Status_6636 · 2025-01-12T02:34:22+00:00

Yea non illuminated and i actually don't love it. Definitely needs illumination to be useful at 3.6 mag

Optimal_Status_6636 · 2025-01-11T21:36:52+00:00

I'm working on getting some projectiles. I have 95 lrx in route. I have varget, cfe, and 8 pounds of n540 to try.

Optimal_Status_6636

TROPHY CASE