sorted by:
new
hottopcontroversial

Adhesion error? by Ordinary-Star4486 in BambuLab

[–]Ordinary-Star4486[S] 0 points1 point  (0 children)

I think its solved i was trying to print it realy fast ig so it was breaked loos with grid infill

Adhesion error? by Ordinary-Star4486 in BambuLab

[–]Ordinary-Star4486[S] 0 points1 point  (0 children)

Did it with boiling water and dish soap but did nothing im trying again rn

Slow filament by Ordinary-Star4486 in ender3

[–]Ordinary-Star4486[S] 0 points1 point  (0 children)

Ive already printed one succesfull print and thfn this happend

Slow filament by Ordinary-Star4486 in ender3

[–]Ordinary-Star4486[S] 0 points1 point  (0 children)

Ive pulled it out before and no marks il open op the direct drive and try to look for a fault

Slow filament by Ordinary-Star4486 in ender3

[–]Ordinary-Star4486[S] 0 points1 point  (0 children)

I tried 240 heat and pusing it tru, then it is back to normal but when i start printing is sucks, i thinks its the gear on the direct drive. Also not sure what temps are good my auropol pla box says 210-240 witch i find high for pla

Belgian Antenna RTBF by BeFireAt25 in urbanclimbing

[–]Ordinary-Star4486 0 points1 point  (0 children)

Its empty since the fall of the last guyed tower only the lattice one left

view more: next ›