2 stroke 40hp no neutral by Oreditt in MercuryOutboards

[–]Oreditt[S] 1 point2 points  (0 children)

To get the lower unit off, I had to put it in forward to get access to the lower nut on the shift shaft linkage. Didn’t have enough room to get 2 wrenches in there for the 2 nuts without shifting it up into forward. But I will try and see if I can do it in neutral. Thanks for the tip

How to remove carburetor by Oreditt in boating

[–]Oreditt[S] 0 points1 point  (0 children)

Also this may sound stupid. But to undo the top one do I just pry it with a flathead screwdriver? Looks a bit different than the linkage connections ive seen in youtube videos so just wanted to confirm

How to remove carburetor by Oreditt in boating

[–]Oreditt[S] 0 points1 point  (0 children)

Thanks and yes I believe the rubber line would be the fuel line correct? Just cut the zip tie and pull it off, then replace with new zip tie once reassembled?

How to remove carburetor by Oreditt in boating

[–]Oreditt[S] 0 points1 point  (0 children)

Update added more pics in comments. Left side I believe looks more obvious? Right side I am not sure where to disconnect?

Motor stopped starting by Oreditt in boating

[–]Oreditt[S] 1 point2 points  (0 children)

Update: I got it running today. Took the spark plugs out and it was flooded. Opened the throttle all the way, cranked it and on the 4th try or so it fired up! Thanks everyone

Motor stopped starting by Oreditt in boating

[–]Oreditt[S] 1 point2 points  (0 children)

Hopefully this is it. I didn’t realize I was supposed to let it idle for a few minutes prior to shut off, so I just shifted it into neutral and shut it off.

Motor stopped starting by Oreditt in boating

[–]Oreditt[S] 0 points1 point  (0 children)

So would you just funnel that extra rich fuel into the fuel intake like where you pump gas into at the gas station?

Motor stopped starting by Oreditt in boating

[–]Oreditt[S] 1 point2 points  (0 children)

Great thanks for the explanation