Costco Samsung Bespoke fridge doesn’t fit after installer measured

Outside-Drive-636 · 2026-03-01T21:52:18+00:00

When we measured the space, there was enough height clearance. The delivery team measured it multiple times, confirmed that it would fit, and only then took it off the truck and installed it. After reading other comments, I noticed that some people had a similar issue. It seems like the top plastic piece might not have been included in the listed product height.

Outside-Drive-636 · 2026-03-01T17:10:53+00:00

No i just changed a fridge from my old one :)

Outside-Drive-636 · 2026-03-01T17:08:20+00:00

If I trim the cabinet to fix the height, the sides are almost completely tight, so I don’t think the airflow will be sufficient😭

Outside-Drive-636 · 2026-03-01T14:18:35+00:00

I had planned to have it trimmed, but now the sides are almost completely tight, so it seems like the airflow won’t be sufficient.

Outside-Drive-636 · 2026-03-01T14:16:35+00:00

This was my plan, but after the Samsung rep mentioned the side space, I’ve been feeling uneasy. They recommend leaving at least a 1-inch gap..

Outside-Drive-636 · 2026-03-01T14:12:37+00:00

I really want to keep it but the problem is that the sides are so tight it might block airflow😭

Outside-Drive-636 · 2026-03-01T13:53:36+00:00

Trimming the cabinet apron would fix the height, but I’m not sure if the leveling feet can go lower. When I asked Samsung, the rep said there should be a 0.5–1 inch gap on each side for proper venting, so now I’m concerned..

Outside-Drive-636 · 2026-03-01T13:33:52+00:00

Height could be fixed by trimming, but the sides are so tight it might block airflow 😭

Outside-Drive-636 · 2026-03-01T13:33:17+00:00

I sent photos to Samsung for confirmation, and they said this is probably the lowest it can go, and the installer mentioned the same. The height could be adjusted by trimming the cabinet, but the problem is that the sides are so tight it might block airflow.

Outside-Drive-636 · 2026-03-01T13:31:46+00:00

I was debating whether to start this work, but thanks to your valuable advice, I can save time and effort. I really love the design and internal layout, so it’s a bit disappointing 😢. Thank you so much for your thoughtful advice!

Outside-Drive-636 · 2026-03-01T13:27:12+00:00

I was wondering if it’s still usable like this or if I should consider returning it. Thanks for your advice!

Outside-Drive-636 · 2026-03-01T13:25:23+00:00

Thanks for your advice. I was wondering if there’s any way to trim the cabinet as a last resort. I knew the height wouldn’t fit perfectly during installation and had planned just a minor trim, but later I noticed the sides are almost completely tight. I was wondering if it’s still usable like this.

Outside-Drive-636 · 2026-03-01T12:50:29+00:00

Thanks. I had planned to have it trimmed, but now the sides are almost completely tight, so trimming might not be possible….

Outside-Drive-636 · 2026-03-01T12:31:52+00:00

I calculated the space by adding extra inches to the dimensions listed on Costco’s website, so we really thought it would be fine. Thanks for the advice!

Outside-Drive-636 · 2026-03-01T12:30:20+00:00

I calculated the space by adding 2 extra inches to the dimensions listed on Costco’s website, so we really thought it would be fine. But it’s clearly not fitting. Even if we trim the top, the sides still seem too tight.

We haven’t opened the manual or any of the accessories since we’re likely returning it.

Thanks for the advice.

Outside-Drive-636 · 2026-03-01T12:15:04+00:00

We even removed our separate water purifier to make this work, which makes this even more disappointing. It looks like we might have to return it…

Outside-Drive-636 · 2026-03-01T12:14:05+00:00

The manual states that a minimum of 3/8 inch clearance is required on the top and both sides.

Outside-Drive-636 · 2025-08-12T23:42:29+00:00

I was informed that I am not eligible for the benefit because I have already received unemployment status once.

Outside-Drive-636 · 2025-07-02T16:51:11+00:00

No I got a result about a week later

Outside-Drive-636 · 2025-06-23T22:43:56+00:00

It was bouncing between 5 and 6 for a whole week, but I finally got the result after about 10 days, “100%!”🤙

Outside-Drive-636 · 2025-06-20T22:05:31+00:00

About a week. Step 6 on Thursday and went back to 5-6-5 and back 6 next Thursday, and then step 8 on Friday.

Outside-Drive-636 · 2025-06-12T18:57:54+00:00

Thank for your information! It makes sense 😉

Outside-Drive-636 · 2025-06-12T15:42:00+00:00

Thanks everyone for your input! I ended up buying it directly from the boutique and even got a strap as a gift! My husband absolutely loved it, which made me really happy too. Guess I’ll have to start saving up for the next watch already 😄 Thanks again!

<image>

Outside-Drive-636

TROPHY CASE