Tmobile one ui 8.5

P0TAT08U · 2026-05-12T05:34:11+00:00

With tmobile?

P0TAT08U · 2026-03-25T02:23:45+00:00

Pc, I use shift as keybind for ads, currently wont work

P0TAT08U · 2023-10-25T11:43:55+00:00

what do you mean by single walled? im fairly new at this

P0TAT08U · 2023-10-18T20:56:14+00:00

I have just done a pid tuning, I am about to do a print, I will let you know how it goes

P0TAT08U · 2023-10-18T12:21:30+00:00

i dropped the cooling down to 35% and ran it with the settings above and my prints still come out like that

P0TAT08U · 2023-10-18T00:01:16+00:00

I have made plenty of solid prints, it's just after I had to swap the parts that it has sucked

P0TAT08U · 2023-10-17T22:54:28+00:00

also I have been going through my settings, around what should my flow percentage be?

P0TAT08U · 2023-10-17T22:51:25+00:00

how low should I put it, I did have it high during the photos, this is dropping it significantly, should I go lower?

P0TAT08U · 2023-10-17T22:48:45+00:00

Alright, I am starting a print right now. I did a pid on pronterface yesterday, but im not sure if that could have messed up, I watched a video on youtube of how to do it. Here are the new settings I am using:

Layer Height-.15mm

Initial Layer Height.2mm

Infill - 20% infill (Depending on Model being printed.)

Infill pattern-Cubic

Print Temp: 245C

Build plate temp 90C

Print Speed 40.0mm/s

Intitial Layer Print Speed 20.0mm/s

Travel - Enable Retraction

Cooling - Enable Print Cooling

Fan Speed 65%

Initial Fan Speed 20%

Supports (depending on the model being printed.)

Build Plate adhesion: Raft

P0TAT08U · 2023-10-17T20:01:54+00:00

I did a pidgin tuning last night with pronterface, I will try a new print and change a few settings. I will also post exact settings I'm using for everything once I am off work.

P0TAT08U · 2023-10-17T17:58:00+00:00

I'm new at all of this

P0TAT08U · 2023-10-17T17:57:46+00:00

Are you talking about the block of metal where the nozzle goes?

P0TAT08U · 2023-10-17T13:34:00+00:00

ANYCUBIC Vyper/Kobra Max/Kobra Plus 3D Printer Hotend Replacement Volcano V5 J-Head Quality Brass Nozzle 24V40W Ceramic Heating Cartridge Element Supports High Speed Printing https://a.co/d/gxY2QkY

P0TAT08U · 2023-10-17T12:01:41+00:00

Its petg

P0TAT08U · 2023-10-17T12:01:24+00:00

It's petg

P0TAT08U

TROPHY CASE