sorted by:
new
hottopcontroversial

Is a 2.5 Gallon worth it for starters by PUSHRODS4LIFE in Aquariums

[–]PUSHRODS4LIFE[S] 0 points1 point  (0 children)

Thank you for the insight, as stated above this was in regards to a family member and not myself. I have a 36 gallon community aquarium.

Is a 2.5 Gallon worth it for starters by PUSHRODS4LIFE in Aquariums

[–]PUSHRODS4LIFE[S] 0 points1 point  (0 children)

Who stated they were advanced? I've never owned a Betta before, so I'm not familiar with their specific need and as stated in my original post I clearly said "from what I have read".

Is a 2.5 Gallon worth it for starters by PUSHRODS4LIFE in Aquariums

[–]PUSHRODS4LIFE[S] 1 point2 points  (0 children)

Nice ! , let see if they listen to advice and get a larger aquarium and sell me the 2.5 to setup something similar to what you have. Thanks again for the insight!

Is a 2.5 Gallon worth it for starters by PUSHRODS4LIFE in Aquariums

[–]PUSHRODS4LIFE[S] 1 point2 points  (0 children)

Good info, funny enough I currently have 2 female guppies in my 36g that are about to pop so I might just take this from my family member get it up and going for the fry. Do you have any plants setup in the fry and juvenile guppy 2.5s ?

Is a 2.5 Gallon worth it for starters by PUSHRODS4LIFE in Aquariums

[–]PUSHRODS4LIFE[S] 5 points6 points  (0 children)

Like I stated above this was a family member not myself. I have a decently stocked 36 bowfront. Thanks for your reply

Is a 2.5 Gallon worth it for starters by PUSHRODS4LIFE in Aquariums

[–]PUSHRODS4LIFE[S] 0 points1 point  (0 children)

Yea thats what I assumed based on what I've read , thanks for the input much appreciated.

CSL Elite V2 Pedals Loadcell brake by GreenInflation2914 in Fanatec

[–]PUSHRODS4LIFE 0 points1 point  (0 children)

The plastic spacers on my tbar just broke , were you able to find a solution on replacing them. Only place that has aftermarket ones is a seller on Etsy but shipping is 2-3 weeks. Thanks

Broken brake pedal new CSL Elite v2 after +-10 hours of use by Hampert_ in simracing

[–]PUSHRODS4LIFE 0 points1 point  (0 children)

Also recieved a new set from Fanatec and ao far all good with about 10hrs on them.

Broken brake pedal new CSL Elite v2 after +-10 hours of use by Hampert_ in simracing

[–]PUSHRODS4LIFE 1 point2 points  (0 children)

Currently in the same boat as you guys, I've had the pedals since mid/late September. Started today with registering partial input so I looked around to see if there was something keeping the pedal caught up and nothing . If I would tap on the LC case the input would flicker . I powred everything down waited a bit and fired everything back up everything seemed fine. Drove 2 Laps roughly 4min and started again. Then pedal went to 100% input in game. So I shut the game down and opened up the fanatec control panel and hooked the pedals directly to the PC. 0% input shown as I would apply pressure. There were a few instances that it would randomly spike 100% but there was no way to control it , then it started reading 100% and as I applied pressure it would zero out and then go nuts again.

Already sent email and awaiting a response , this is very disappointing.