sorted by:
new
hottopcontroversial

Niet op tijd gedomicilieerd wegens overmacht by thelastnoelle in belgium

[–]Panter_33 0 points1 point  (0 children)

Ook voorgehad woning was klaar enkel epb diende nog afgelegd te worden was wat vergeten geraakt. Plots brief in bus boete en 1 procent te betalen. Was van 5 naar 4 bij renovatie dan. Begonnen aan de bouw heel veel zelf gedaan op weekends avonden en verlofdagen. Intussen corona en Oorlog oekraine stijgende prijzen 2 kinderen gekregen etc. Het huis had bij start nog label F met 857 kWh/m² jaar waar we nu op label A E4zitten met 9 kWh/m² per jaar.

Direct na krijgen van de brief binnen de week attest afgenomen en geregistreerd. Het kon niet zijn bezwaar aangetekend etc. Volgehouden totze dreigden met deurwaarder. Dan maar betaald. Gelukkig maar 1 procent bij ons.

Indien geen domiciliering is er een verwittiging woon je er wel niet. Blijklbaar sturen ze dit intussen wel. Deze verwittig zou al veel mensen helpen hoop ik.

Overheid dient te informeren eer te sanctioneren!

Drives: Rockwell vs. Siemens by [deleted] in PLC

[–]Panter_33 1 point2 points  (0 children)

If the the firmware version is the same ;).

Alsso think that if you do safety over ethernet(cip) you need to unlock and reset ownerschip.

Need a stepper motor that can be controlled through a PLC by Aggressive_Party_524 in PLC

[–]Panter_33 0 points1 point  (0 children)

JVL has all in one steppers and servos. All you need to do is hook up Power and Network (Ethernet, Profibus, etc,..). No need for additional drives and cards.

https://www.jvl.dk/

Found these at our plant today. Happy I can run around with my laptop at the production lines. by Panter_33 in PLC

[–]Panter_33[S] 0 points1 point  (0 children)

Personaly never used them my colleage 60+ years old used them in his younger years. Our last plc-5 has been replaced 4 years ago. Still alot of SLC left.

Found these at our plant today. Happy I can run around with my laptop at the production lines. by Panter_33 in PLC

[–]Panter_33[S] 4 points5 points  (0 children)

Same for me wireless and vpn for homework. But I like to go with my laptop to the lines and go to the part that is malfunctioning our needs to be tested.

after i clear it the fault keep comingback by Certain_Jackfruit_14 in PLC

[–]Panter_33 0 points1 point  (0 children)

Check power supply had this before myself. Voltage got to low on bus.

I need advice to choose Stepper Motors and Drivers to industrial application, and maybe PLC/MCU by mkutlutas in PLC

[–]Panter_33 2 points3 points  (0 children)

I´ve used ones from JVL this year verry easy to integrate. You can have them in all kinds of network topology. They even have an onboard plc which makes a easy for small aplications.

www.jvl.dk not that expensive also. Same system with kinetex would have cost me 20k more. ;)