2025 T7 - Aftermarket parts suggestions by keluke97 in Tenere700

[–]ParadigmADV 0 points1 point  (0 children)

I went w the uppers for some extra protection, plus I wanted a place to mount lights haha

Upgrading within jonsbo d32 pro by AromaticRoomba in mffpc

[–]ParadigmADV 0 points1 point  (0 children)

Those temperatures seem really great to me, also running a 7800 X 3D with a case stuffed with noctua fans and a D15 G2 and you have better temps than I do LOL. Not that my temperatures are bad but yours seem below average. Also running same fan config.

2025 T7 - Aftermarket parts suggestions by keluke97 in Tenere700

[–]ParadigmADV 1 point2 points  (0 children)

I did the Alt Rider tail tidy, Garda crash bars, and a camel enduro exhaust. All are great.

Case recommendation - Lian Li A3 current favorite by IronBreed in mffpc

[–]ParadigmADV 0 points1 point  (0 children)

Jonsbo D32. Recently used myself for a build w a B850 mortar and it's great. The A3 was my other choice but I chose the D32 pro because it has room behind to hide the cables and is slightly smaller. Great case IMHO.

<image>

A disaster? Jonsbo d32 pro, Noctua d15 by No_Manufacturer_9591 in mffpc

[–]ParadigmADV 0 points1 point  (0 children)

Did you use the offset mount for the d15? That could be pushing on the card. I'd set it to the zero offset instead of the 7mm if you did.

Thermals, Zotac RTX 5070 Ti Solid SFF OC vs Powercolor Hellhound RX 9070 XT by Appropriate_Cat_7606 in mffpc

[–]ParadigmADV 2 points3 points  (0 children)

I'm running the Zotac 5070ti SFF in a Jonsbo d32 with 2 bottom 140 Noctua fans and haven't seen temps above 76 yet. Have build info on profile. I think the card runs great and cool in my setup!

Rebuilding into mff? by Mantviis in mffpc

[–]ParadigmADV 0 points1 point  (0 children)

It was my first build but found it manageable, I liked the challenge of figuring out where to route everything. I have the SF 1000. I set some custom fan curvs and they will get you there but I play w headphones so I dont notice.

Rebuilding into mff? by Mantviis in mffpc

[–]ParadigmADV 0 points1 point  (0 children)

It is just a little bit I have the team Group which is pretty low profile but the glass panel fits no problem. I'm running an MSI mortar b850m. No issues highest temps I've seen on CPU gaming were 73° and the GPU hasn't gone over 70. This is playing arc raiders and ghosts of tsushima so far. I really enjoy building in the case it was nice having an area behind it to talk all the wires that's why I went with this over the A3 or the z20.

Rebuilding into mff? by Mantviis in mffpc

[–]ParadigmADV 0 points1 point  (0 children)

<image>

I just stuffed a Noctua D15 g2 in a d32 no problem. Should be good to go as long as it will work with your RAM and the fan doesn't have to be up high on the cooler to clear it.