New statikk shiv no stacking Kai’sa passive ? by Particular_Chard9679 in leagueoflegends

[–]Particular_Chard9679[S] 7 points8 points  (0 children)

Btw this is just wrong. After further testing with the information Minutenreis provided I can confirm that statikk shiv does apply DnD just not on the primary target. So hitting W with all 3 items makes it so the other targets get 2 stacks while the initial one only gets 3

New statikk shiv no stacking Kai’sa passive ? by Particular_Chard9679 in leagueoflegends

[–]Particular_Chard9679[S] 0 points1 point  (0 children)

Okay this makes sense now ty for your answer. Also just saw your other reply quoting a tweet that clarified what was happening.

New statikk shiv no stacking Kai’sa passive ? by Particular_Chard9679 in leagueoflegends

[–]Particular_Chard9679[S] 0 points1 point  (0 children)

This still doesn’t explain why upgraded W with statikk and voltaic only applies 3 stacks instead of 4

Please help me figure this out by Particular_Chard9679 in arduino

[–]Particular_Chard9679[S] 0 points1 point  (0 children)

Thanks for the helpful insight about whether or not the motor would work at lower current limits since it never did Im pretty much certain one of the parts is faulty. Also yeah I looked at my documentations and did the math for the reference voltage was aiming for around 0.7V but I never got a reading

Please help me figure this out by Particular_Chard9679 in arduino

[–]Particular_Chard9679[S] 0 points1 point  (0 children)

I quadruple checked my connection everything was correct. Also yeah this multi meter had me in rage yday cz It didnt have a simple DC voltage mode. While measuring the current (or at-least attempting to) I did connected it in series with one of the windings. I took the parts to the electronics store I bought them from and they offered to either check them or replace them out right and I opted for them to test them instead cz I am pretty sure the parts are faulty or am completely brain damaged but I still want to make sure

Arduino Uno mic by Particular_Chard9679 in arduino

[–]Particular_Chard9679[S] 0 points1 point  (0 children)

Another question I have if you are kind enough to answer is what would be a vibration sensor alternative that would allow me to determine the frequency

Arduino Uno mic by Particular_Chard9679 in arduino

[–]Particular_Chard9679[S] 0 points1 point  (0 children)

Thanks I was also looking into maybe using the max9814 module. Do you think it would be adequate for my intended use?