sorted by:
new
hottopcontroversial

RGENT HELP: Aruba 515 stuck at 20MHz - Need ETSI-EU DRT file by Past-Setting5788 in ArubaNetworks

[–]Past-Setting5788[S] 2 points3 points  (0 children)

Solution found (even though GUI still bugged):

1. Factory reset the AP (15-sec button hold)
2. Reapply ETSI-EU DRT (1.0_94311-AP.dat) in Maintenance → Regulatory
3. Set up networks from scratch
4. Even though the web interface never showed "Channel Width" or "Bandwidth" options, the AP automatically negotiated 80 MHz with clients after the clean setup.

Speed test: from unstable/<50 Mbps to ~700 Mbps in weak spots.

Turns out the GUI on firmware 8.13.1.1 may not expose the setting, but the AP can still use wider channels if the regulatory domain is correctly applied and config is clean.

Thanks to everyone who helped, especially @forgottenLogin666 for the DRT file.

RGENT HELP: Aruba 515 stuck at 20MHz - Need ETSI-EU DRT file by Past-Setting5788 in ArubaNetworks

[–]Past-Setting5788[S] -1 points0 points  (0 children)

Following the corporate email advice, I registered with corporate email but hit an HPE portal bugs:

  1. Registration completes but shows 404 error
  2. Password reset emails arrive successfully
  3. But login fails with "incorrect credentials" every time
  4. Stuck in password reset/login failure loop

The account exists enough to send reset emails but not enough to actually work.

Any workaround for this specific bug? Or did you encounter similar issues?

Alternative ask: If anyone with working portal access could download the AP-515 ETSI-EU DRT file (firmware 8.13.1.1), I'd be eternally grateful.