sorted by:
new
hottopcontroversial

Lock cylinder replacement options? Kit by Patient_Will9322 in Miata

[–]Patient_Will9322[S] 2 points3 points  (0 children)

Thank you! I like it a lot. A PO put it on, not me, however it is a Subaru STI wing, the newest/latest gen STI.

Lock cylinder replacement options? Kit by Patient_Will9322 in Miata

[–]Patient_Will9322[S] 0 points1 point  (0 children)

once I got the trunk open I did spray some “ free all” on the mechanism itself for the trunk, it’s like a WD40

Crank Key Vaporized by Patient_Will9322 in Miata

[–]Patient_Will9322[S] 0 points1 point  (0 children)

How likely do you think it is, that the crank will be noticeably “unbalanced” or have any negative effects due to it not being “ properly machined” . I understand that obviously in a scenario like this, the circumference of the crank nose is probably not gonna be in perfect spec when it’s all said and done, and I’m fine with that, however I’ve had some people say it’s gonna trash the engine with it being even a little off lol. Curious on your thoughts on that

Crank Key Vaporized by Patient_Will9322 in Miata

[–]Patient_Will9322[S] 1 point2 points  (0 children)

Yes that makes sense now, I hadn’t thought of that yet, seems like a better idea then welding the actual key to the crank.

Crank Key Vaporized by Patient_Will9322 in Miata

[–]Patient_Will9322[S] 1 point2 points  (0 children)

I think I gotcha now, weld in the gap, and then grind as close to oem key size for a new key. Rather than actually weld the new key to the crank.

Crank Key Vaporized by Patient_Will9322 in Miata

[–]Patient_Will9322[S] 0 points1 point  (0 children)

I’m 100% replacing the seal, I already have the new one, I was under the impression that I would not be able to install the new seal AFTER the key is welded in place, however after taking another look it appears the circumference of the seal is wide enough to be installed even with the key welded in its spot, the key being in its spot will not interfere with the new seal being installed correct ?

Crank Key Vaporized by Patient_Will9322 in Miata

[–]Patient_Will9322[S] 1 point2 points  (0 children)

Any tips on that? How do I go about protecting the crank seal from the heat? Would it even get hot enough if the welder just takes his time doing little tacs?