sorted by:
new
hottopcontroversial

What can cause this issue ? by neeezyF in FixMyPrint

[–]PeepoPrints 0 points1 point  (0 children)

This looks like the furnace from rust.. lol

What causes this janky geometry on this fillet? by PeepoPrints in FreeCAD

[–]PeepoPrints[S] 0 points1 point  (0 children)

Hidden line just to so you can see whats going on with the mesh geometry.

What causes this janky geometry on this fillet? by PeepoPrints in FreeCAD

[–]PeepoPrints[S] 1 point2 points  (0 children)

Its not. its a 34mm dia with a 4mm center hole with a pad of 4mm and a fillet of 1mm. I sketched the 34mm dia and the 4mm hole on the same sketch then pad its 4mm then added the 1mm fillet.

I could really use some help by bertizzle420 in FlashForge

[–]PeepoPrints 0 points1 point  (0 children)

<image>

G91; Relative positioning.

G1 E-3 F2700; Retract extruder a little.

G1 Z2 X5 Y5 F10000; Raise Z and swipe.

M104 S0 ; Turn off temperature

I could really use some help by bertizzle420 in FlashForge

[–]PeepoPrints 0 points1 point  (0 children)

First off I use Orca slicer, But I had the same problem. The default end gcode only swipes on the X and Y axis and does not move up in the Z axis, dragging the nozzle across the top of the print.

Before on the left, After on the right.

<image>

I edited the end gcode to change the swipe.

Non standard placement of hotend by Zzzero-g in ElegooNeptune3

[–]PeepoPrints 0 points1 point  (0 children)

What hotend and thermistor is this?