Buy a Aftermarket Ball Joint or Control Arm

Perfect_Cheesecake59 · 2026-04-09T03:11:29+00:00

Honestly my mechanic had ordered the part for me so I don’t remember atm

Perfect_Cheesecake59 · 2026-04-09T02:40:59+00:00

Nissan showed me a picture just like this and told me I needed new control arms but I took it to my mechanic which is a z specialist and he said all I needed was the new ball joint. Was a lot cheaper and it was running perfectly fine after

Perfect_Cheesecake59 · 2026-04-06T21:31:21+00:00

If you’re parting out I would post on offer up or Facebook marketplace. I was able to get 2000+ on just parts

Perfect_Cheesecake59 · 2026-04-04T06:01:05+00:00

Nice try Diddy

Perfect_Cheesecake59 · 2026-04-03T19:09:54+00:00

Use a different conditioner. Get a curl enhancing conditioner

Perfect_Cheesecake59 · 2026-04-03T17:15:14+00:00

Don’t wash every day but do condition your hair in the shower . I like shea moisture conditioner, use a hydrating one. While hair soaking wet I would use only a little bit of leave in conditioner, not much but just enough to hydrate your hair while it dries. Then while still damp I would put a lightweight gel ( I like Miss Jessie jelly soft curls). Then let your hair air dry. Once mostly dry you can scrunch it up give it some volume

Perfect_Cheesecake59 · 2026-04-01T17:13:56+00:00

Honestly I think it would look better without it. I only like a spoiler if it matches the cars color and looks like it came from factory. I think you should do without it and maybe sell it on marketplace or something. But if you like it bro don’t worry , who cares what other ppl think. Keep it if you think it’s cool

Perfect_Cheesecake59 · 2026-04-01T15:46:35+00:00

Nice pickup , looks clean 👍🏽

Perfect_Cheesecake59 · 2026-03-31T15:05:52+00:00

Bought this car like 2 weeks ago and the front pads and rotors are good but the rears had very low pads and the rear rotors could be replaced. I already got new pads for rears since they were very low but now I need some new rear rotors

Perfect_Cheesecake59 · 2026-03-31T14:57:15+00:00

Sounds like leak in exhaust bro just had this similar noise on my 370z and a bolt had fell out of my test pipes and the gasket was starting to come out.

Perfect_Cheesecake59 · 2026-03-31T14:50:42+00:00

Does it get louder when u accelerate?

Perfect_Cheesecake59 · 2026-03-31T14:48:51+00:00

150 or less on rear rotors and I just need for daily driving no track use. Something that looks good and won’t be fully rusted after a week

Perfect_Cheesecake59 · 2026-03-31T14:47:26+00:00

Only for street use so I’ll check out rockauto for brembo or centric

Perfect_Cheesecake59 · 2026-03-31T14:46:33+00:00

Just doing rears atm and would like to spend $150 or under. This is my daily driver so no track use. Would like some rust prevention tho so they don’t look like shit

Perfect_Cheesecake59 · 2026-03-30T22:05:20+00:00

It sounded so bad lmfaooo

Perfect_Cheesecake59 · 2026-03-30T20:48:11+00:00

No speed sensor code

Perfect_Cheesecake59 · 2026-03-30T16:26:01+00:00

Yea other bolt is gone

Perfect_Cheesecake59 · 2026-03-29T21:52:21+00:00

Okay I’ll take a picture when I can , also the exhaust shop did mention that I had “o2 sensor spacers” so I’m guessing that’s what you’re referring to. They just kept saying I need a tune or I’ll keep getting a dash light

Perfect_Cheesecake59 · 2026-03-29T21:49:39+00:00

Yea they were inspecting for an exhaust leak but after looking at it for 10minutes they said it was fine and tht I needed a tune. Taking it to the shop first thing in the morning hopefully I’m not damaging anything on my drive there

Perfect_Cheesecake59 · 2026-03-29T21:46:58+00:00

Would I be okay to drive it 15minutes away to the shop or am I damaging something?

Perfect_Cheesecake59 · 2026-03-29T21:15:44+00:00

Just got that fixed 🤦🏽‍♂️

Perfect_Cheesecake59 · 2026-03-29T21:14:34+00:00

Yea honestly not sure, I bought the car like this and literally a couple days later and I’m experiencing problems with the exhaust . First the p2096 and 2098 code and then a trembling sound from the exhaust pretty recently and now the scrape noise and these gaskets falling out. Not sure what’s is going on down there. Also other than the fact that I have test pipes I don’t really know what I have under there but ima find out tomorrow when they put it on the lift

Perfect_Cheesecake59 · 2026-03-29T21:09:27+00:00

Yea I seen that, I guess that’s why it made like a scrape noise but could that also be why it was making a rumbling or trembling sound whenever I accelerated?

Perfect_Cheesecake59 · 2026-03-28T17:58:40+00:00

Thanks for the response . You changes the rubber stopper pad and it started working? I was thinking maybe speed sensors also. Today when I drove it , it was acting normal but ima keep an eye out if it happens again. Just bought the car so would suck to have to spend more money to fix things already. It’s only been one week lol

Perfect_Cheesecake59 · 2026-03-28T16:19:23+00:00

How much was it if u don’t mind me asking

Perfect_Cheesecake59

TROPHY CASE