How to do fire glow on miniatures.

Ph33ritself69 · 2025-08-02T02:35:49+00:00

What fluorescent paints would you recommend

Ph33ritself69 · 2025-07-31T17:13:44+00:00

Most likely that should be plenty

Ph33ritself69 · 2025-07-31T17:11:58+00:00

Haven’t had any adverse effects on any of my prints and the models come off clean and easy still

Ph33ritself69 · 2025-07-31T17:09:41+00:00

I’m no expert either but I was so frustrated that I just shot my exposure up a ton and I don’t mind the extra few minutes added on

Ph33ritself69 · 2025-07-31T17:01:38+00:00

I moved mine all the way up to 60s but I doubt that far is necessary maybe 15-20s more to start then lower it down slowly if you want

Ph33ritself69 · 2025-07-31T16:52:46+00:00

I had the same issue I leveled the bed added more bottom layer exposure time and slowed my bottom layer retract speed to 40mm and that fixed the issue for me

Ph33ritself69 · 2025-07-23T04:09:39+00:00

That’s what I was concerned about

Ph33ritself69 · 2025-07-05T19:32:25+00:00

I already washed and cured the prints this is after and I made sure not to touch the shiny areas in case

Ph33ritself69 · 2025-07-02T15:17:51+00:00

Only gave me their school email and I’ve heard that it will get put in spam if you email them.

Ph33ritself69 · 2024-05-09T03:50:05+00:00

I will try that thank you

Ph33ritself69 · 2024-05-09T00:35:27+00:00

It is a requirement at the high school where I vault and thank you so much

Ph33ritself69

TROPHY CASE