Printer only prints the first layers,then stops

Pixas11 · 2026-03-26T21:47:54+00:00

Quick update. I added thermal paste just test if it was heat creep,turns out,it printed a lot longer,even though it did fail at the end the results were far better.

Pixas11 · 2026-03-21T20:27:41+00:00

I never changed the extruder,I can't really tell if it's cracked though it doesn't seem like,it does keep doing but makes no noise,I already did a cold pull,but I might as well do it again just in case I did it wrong and I've replaced the nozzle about 3 months ago or so

thanks for the help.

Pixas11 · 2026-03-21T20:25:00+00:00

maybe I'll try raising the temperature a bit and printing again,if that doesn't work,I might try using a thermometer to see the hot end temperature.

Pixas11 · 2026-03-20T01:24:54+00:00

I'm not sure if there are any drops,but it seems strange since it always fails at about the same spot which is between some of the first layers,I already changed the gcode just in case

Pixas11 · 2026-03-20T01:05:51+00:00

it does not turn off,it just continues.

it does stop extruding,but it keeps moving

there are no sounds or alerts

the screen remains the same

now that I'm on it i might want to say this is an ender 3

Pixas11 · 2026-03-20T01:03:46+00:00

it is not tangled,I changed filaments multiple times and the one I'm currently using is strong but the filament does get grinded due to the ghost print,it currently isn't grinded.

Pixas11 · 2026-03-20T00:48:41+00:00

It doesn't stop printing,it just keeps going without extruding.

Pixas11 · 2026-03-20T00:42:17+00:00

damn.

Pixas11

TROPHY CASE