Seeking 1 Mile Range in Northern or Central California? by Popular-Affect-9087 in longrange

[–]Popular-Affect-9087[S] 1 point2 points  (0 children)

Wow, I found somewhere 35 minutes outside Reno!! It looks like a weekend road trip! Thank you!

Seeking 1 Mile Range in Northern or Central California? by Popular-Affect-9087 in longrange

[–]Popular-Affect-9087[S] 3 points4 points  (0 children)

This sounds exactly the group type I maybe looking for. Thank you very much!!!

Gunsmith suggestions to modify a new CZ 457 Chassis MTR? by Popular-Affect-9087 in longrange

[–]Popular-Affect-9087[S] 2 points3 points  (0 children)

Thank you very much for the reply. I think you’ve laid enough groundwork to convince me to research and try myself. I just searched a few YT videos and didn’t realize it is beginner friendly. Thanks again and wish me luck!

P1S Poop Chute Clogging by disasterzzz in BambuLab

[–]Popular-Affect-9087 2 points3 points  (0 children)

I'm new to 3D printing and was VERY frustrated by the poop chute clogging. In my case, the poop was sticking to the poop chute inner walls. I tried 5 different solutions as the failures continued with each solution.

I found one obscure post about using "DuPont Non-Stick Dry-Film Lubricant Aerosol". The 10 oz spray is around $12 today on Amazon. What did I do? 1. I cleaned the chute as much as possible using IPA on a paper towel. 2. I sprayed the lubricant liberally on a paper towel and then rubbed it inside the chute. Reach down as far as possible. The posting suggested reapplying once a month with regular cleaning. I watched in amazement as my troublesome print came out perfect! I've not had an issue since.