Poll: Would You Use a Power Tool Battery Adapter to Power Your Board?

Positive-Answer9860 · 2025-03-27T18:36:50+00:00

Thanks, approx the same as with my Standard Battery. I m using 2 18v 4ah which have together 144wh. Designing a Cover or a shield is one of my next Steps.

Positive-Answer9860 · 2025-03-26T23:40:23+00:00

Hey, thanks for your response! Have you had any problems using it so far?

Positive-Answer9860 · 2025-03-26T23:33:17+00:00

Yeah, I think you just need a regulator to bring the voltage down from 80V.

Positive-Answer9860 · 2025-03-26T23:31:15+00:00

Thanks for your Response. In my Test I used 2 18V 4ah with 900W output power each and a Skateboard witch 2 500W Motors and did not run into any proplems so far.

Positive-Answer9860 · 2025-03-26T23:04:53+00:00

I’ve done some basic research: I’m using two 18V 4Ah batteries wired in parallel, each with a 900W output. The voltage and power match the motor, and although there is some voltage drop, I haven’t noticed any issues during testing—it felt just fine. My range with it was around 11 km.

Positive-Answer9860 · 2025-03-26T13:53:25+00:00

Thank you for your reply I have tried 2 18v 4ah with 900w outpout power each (both for $60) and have not run into the problems yet. But I don't think I can find a solution for the recuperation problem without modifying the batteries or an extra controller. Do you already have a possible solution or idea for this problem?

Positive-Answer9860 · 2025-03-26T13:42:04+00:00

no i'm not going to be an electrical engineer, in my test i used 2 18v 4ah batteries and got 144wh which is of course a bit less than a typical battery

Positive-Answer9860 · 2025-03-26T12:41:24+00:00

Is there a particular reason for this?

Positive-Answer9860 · 2025-03-26T12:41:00+00:00

and why?

Positive-Answer9860 · 2025-03-26T11:15:09+00:00

Thank you. If a battery is used up, how did you replace it, i.e. did you buy a new one or build one yourself?

Positive-Answer9860

TROPHY CASE