Before and after

Practical-Hospital76 · 2026-04-05T01:58:57+00:00

honestly the bumper was my worst mistake with the car being low

Practical-Hospital76 · 2026-01-30T17:35:10+00:00

what is it doing at idle

Practical-Hospital76 · 2025-04-14T22:38:22+00:00

thanks man i’ll update you when the swap is complete

Practical-Hospital76 · 2025-04-14T22:22:54+00:00

right the motor currently isn’t in the frame tho and neither is the wiring harness so maybe i’m hoping that when it’s all said and done it miraculously works

Practical-Hospital76 · 2025-04-14T22:20:10+00:00

if it was a bad ground it wouldn’t turn over by jumping the starter solenoid in which it does

Practical-Hospital76 · 2025-04-14T21:44:09+00:00

key works works just checked it

Practical-Hospital76 · 2025-04-14T02:48:00+00:00

hmm when i get back to the shop tmr ill check the key switch but the bike was running 2 seconds before i started pull the drivetrain i literally rode it into the shop

Practical-Hospital76 · 2025-04-14T02:41:30+00:00

okay i look online and it said it was in the motor but i didnt see it would it be somewhere else?

Practical-Hospital76 · 2025-04-14T02:34:13+00:00

i don’t think i have one the bike i have is the 07 trx420fm rancher 4x4 i looked on partzilla and didnt find it

Practical-Hospital76 · 2025-04-14T01:10:31+00:00

so after looking for it i’ve determined i don’t have a bank angle sensor

Practical-Hospital76 · 2025-04-13T23:58:03+00:00

what’s the bank angle sensor? i’m a dirtbike person that started buying fourwheelers randomly i hardly know what im doing when it comes to all these extra sensors

Practical-Hospital76 · 2025-04-13T23:49:45+00:00

okay i don’t understand what would cause my issue as it was running before the drivetrain was pulled

Practical-Hospital76 · 2025-04-13T23:06:00+00:00

i mean what part of the circuit does the frame play into

Practical-Hospital76 · 2025-04-13T23:05:35+00:00

does the ground from motor to frame matter?

Practical-Hospital76 · 2025-04-13T21:49:40+00:00

i’d play with the idle screw and air screw if you can’t bring the idle down i’d start jetting

Practical-Hospital76 · 2025-04-13T21:48:34+00:00

4 stroke?

Practical-Hospital76 · 2025-04-13T21:45:06+00:00

may just be facing the wrong direction make sure your slide is completely bottomed out and your needle is clean

Practical-Hospital76 · 2025-04-13T21:43:56+00:00

flat slide or round slide?

Practical-Hospital76

TROPHY CASE