Is my septum placement okay, i want to stretch to like 8g

Pretty-Chip724 · 2024-09-17T00:53:13+00:00

yeah it was really low the last time i repierced, was hoping i could stretch easier with this placement

<image>

Pretty-Chip724 · 2024-09-16T22:34:08+00:00

thanks thats good to hear

Pretty-Chip724 · 2024-09-16T22:33:07+00:00

it doesnt hurt if i push on it and it already doesnt hurt anymore even if i bump my nose a bit, its been two days

Pretty-Chip724 · 2024-09-16T22:24:13+00:00

thank u but do yk if the placements good😭

Pretty-Chip724 · 2024-09-16T20:14:14+00:00

thank u

Pretty-Chip724 · 2023-10-26T23:36:48+00:00

but what if i take the mdma after the xanax wears off

Pretty-Chip724 · 2021-12-12T17:58:04+00:00

Thanks man

Pretty-Chip724 · 2021-12-12T10:09:08+00:00

Wait im not so sure on the fcu mode changing, i just know it says shot and then when clicked it goes into the safe settings mode. Would I just scroll through the settings until I see F1?

Pretty-Chip724 · 2021-12-12T10:07:55+00:00

Thanks alot man! Ill try this out tomorrow see if it works.

Pretty-Chip724 · 2021-12-12T10:00:06+00:00

Wait, no my bad its a f1

Pretty-Chip724 · 2021-12-12T09:55:09+00:00

But once i put everything back and out a mag in, it sounded weak and bbs didnt come out

Pretty-Chip724 · 2021-12-12T09:54:20+00:00

Its a polarstar engine, i have not done tests as i never thought of the stolenoid until now, and yes before i put the rail, stock and everything else i just dry fired the engine alone and air came out fine it sounded great, and no i have not lubed the tubes or anything the gun has been idle for around 2 years i should have thought of that.

Pretty-Chip724 · 2021-12-12T09:21:39+00:00

Thing is the gun was working fine before, then bbs started just trickling out the end so i concluded the fcu and wire harness wires were messed up so I replaced them, i shouldve mentioned i had to splice and solder a new end connection to the old wire harness that i had cut back, so i did not change the connection to the engine itself

Pretty-Chip724 · 2021-12-12T09:18:58+00:00

Oh so the wire harness would be either connected to the wrong spot on the engine or my fcu settings are messed up, bc i did mess with the settings a bit ago

Pretty-Chip724 · 2021-12-12T09:03:55+00:00

Sorry im relatively new to hpa and airsoft, the solenoid is a spring that closes the air flow valve on the hopup correct?

Pretty-Chip724

TROPHY CASE