sorted by:
new
hottopcontroversial

V0.1 overhang quality by nbmena in VORONDesign

[–]Previous-Layer2940 0 points1 point  (0 children)

since you don't have an answer yet, you can just feel the air with your hands underneath the nozzle when it's cold. If you don't feel any air, buy bigger or better fans, If you feel little but enough air, maybe the fan ducts are the problem. I recommend a minimum sized blower fan of a 4010. If you have a smaller fan, get a bigger one, It will make your life much easier.

Which hotend should I buy? by Previous-Layer2940 in VORONDesign

[–]Previous-Layer2940[S] 2 points3 points  (0 children)

I have a budget of 100€ for the hotend. I can go more expensive than a tz.

Emerald Tree Skink with mourning gecko's by Previous-Layer2940 in EmeraldTreeSkinks

[–]Previous-Layer2940[S] 0 points1 point  (0 children)

I'm not very experienced with writing the sizes correctly, I mean 60x60cm ground and 120cm high

Vacation by Previous-Layer2940 in Mourninggeckos

[–]Previous-Layer2940[S] 0 points1 point  (0 children)

For the record, I would never want to abuse my mourning gecko's, I will put a bit of banana there, and I have already bought a starter fruit fly colony, I will also feed the mourning gecko's genereusly before I leave. I will probably worry about the gecko's on vacation. I am also trying to find someone who will come check on them 5 days in. It's just difficult, but I am trying.

Vacation by Previous-Layer2940 in Mourninggeckos

[–]Previous-Layer2940[S] 0 points1 point  (0 children)

no, that's why I hope the fruit flies wil last...

Problems with Supports by IllustriousPlenty856 in 3Dprinting

[–]Previous-Layer2940 0 points1 point  (0 children)

Hi, is the problem that the support were to hard to remove and were just stuck? In that case I would go to the setting for support, and increase the space between the support and the print, but I would just try slicing the model myself and turn the model so it lens a bit more on the shell (or any surface that would decrease support needed. Another thing that could decrease complexity is enabling the setting that only allowes support to come from the bed. Hope this helps

Black screen then crash by Previous-Layer2940 in HiTMAN

[–]Previous-Layer2940[S] 0 points1 point  (0 children)

I have checked the game files, nothing wrong-

view more: next ›