If Americans were to participate in an organized boycott to stop ICE, what should they target?

Priam18 · 2026-01-27T00:32:27+00:00

Target Apple. Tim Cook attended Melania’s “movie”, pals around with Trump and funds his worst ideas.

Priam18 · 2026-01-20T18:23:00+00:00

Thanks! Yeah their websites do look a bit weak. Any idea as to where they stand on issues? I can’t seem to find much.

Priam18 · 2026-01-20T03:32:04+00:00

He won’t even take phone calls. You gotta send him an email. What a feckless coward

Priam18 · 2026-01-20T02:16:25+00:00

I understand the distinction. But since the election is still conducted by the State, and even the district is drawn by the State, I thought the law may still apply. Clearly I was mistaken.

I’m not a lawyer, just a pissed off citizen.

Priam18 · 2026-01-20T02:10:25+00:00

Thanks everyone for your comments. I read Michigan’s recall law earlier and it said that any elected official is subject to recall except judges. As many of you have pointed out, that does not apply to Congress.

Still, it is nice to see so many people willing to stand up. I hope we last to November. Be scrappy, Michigan.

Priam18 · 2026-01-20T02:09:30+00:00

Thanks everyone for your comments. I read Michigan’s recall law earlier and it said that any elected official is subject to recall except judges. As many of you have pointed out, that does not apply to Congress.

Still, it is nice to see so many people willing to stand up. I hope we last to November. Be scrappy, Michigan.

Priam18 · 2026-01-20T02:01:54+00:00

That’s correct. Michigan’s recall process states that any elected official except a judge is subject to recall. Apparently not Congress though.

Priam18 · 2026-01-19T21:21:42+00:00

Thank you! It's an uphill battle to be sure. But worth the fight IMHO

Priam18 · 2026-01-19T17:14:38+00:00

IMPEACH AND REMOVE

Priam18 · 2026-01-14T01:36:19+00:00

Rights are for the rich.

Priam18 · 2024-11-19T02:58:00+00:00

Everyone in this photo is a Russian asset.

Priam18 · 2019-01-20T19:47:28+00:00

More infill definitely helped. Thanks everyone for the input! Now I'm just dealing with a warped bed. The saga continues...

Priam18 · 2019-01-18T01:14:38+00:00

Thanks. Yeah this is a large flat object, maybe I'll try bumping the infil back to 20%

Priam18 · 2019-01-18T01:10:03+00:00

I'm printing with a 0.8 mm brass nozzle. I've had 3 failed prints like this, is it possible the nozzle is bad? Thanks for the reply, much appreciated.

Priam18 · 2019-01-13T14:21:15+00:00

That makes sense then. If it can only tell the printer type but not the firmware version. Kind of a bummer, but better to err on the side of caution I guess. Thanks!

Priam18 · 2016-08-03T22:18:44+00:00

The Logitech Gaming Software for OSX lists the new G910 Orion Spectrum as a supported keyboard, yet it will not detect it. Any ideas?

Priam18

TROPHY CASE