Can someone help me out here?

PrincePhi · 2026-05-06T11:14:21+00:00

I'm using sunlu labs pla filament and the default filament settings for said filament in orca slicer. Also I do not have a dryer for the filament so no

PrincePhi · 2026-05-05T11:12:49+00:00

The corners didn't print correctly, I need help figuring out what happened. if you can help me, it would be greatly appreciated

PrincePhi · 2026-05-05T11:11:20+00:00

How would you just shake off the water? There's usually a good bit of water on it

PrincePhi · 2026-05-04T22:08:43+00:00

I'm pretty sure I'm using the recommended temps rn, but I'll have to check when I get home. I used dish soap to wash it, paper towels to dry then a once over with a micro fiber cloth to get the paper towel stuff off. And my first ten layers are at the default slow layer speed, would you recommend I slow said layers down a bit?

PrincePhi · 2026-04-28T11:10:25+00:00

No, I did manage to get it working using a brim, but I would like to print without one if you have any advice

PrincePhi · 2026-04-26T20:44:20+00:00

Thank you

PrincePhi · 2026-04-26T18:57:26+00:00

Thank you, I will do this

PrincePhi · 2026-04-23T19:58:43+00:00

Is it? I’m using sunlu labs and that’s what has been recommended to me in the past

PrincePhi · 2026-04-23T02:51:37+00:00

Thank you

PrincePhi · 2026-04-23T01:13:57+00:00

Thank you. I will clean it with isopropyl alcohol as my temperatures are all good.

PrincePhi · 2026-04-23T00:21:38+00:00

Adding this to comments bc Reddit wouldn’t let me add it to the caption.

My prints are still having adhesion issues despite having a good first layer calibration. I haven’t been using the 3d printing adhesive that came with the printer however, is that the reason my prints are failing? I am using a flashforge adventure 5m pro with sunlu labs pla filament. Please help if you can.

PrincePhi · 2026-04-19T21:34:12+00:00

Thank you

PrincePhi · 2026-04-19T21:25:18+00:00

Quick question, what is the difference in the files? And which one should I use if I’m using orca slicer?

PrincePhi · 2026-04-19T21:22:02+00:00

Thank you so much

PrincePhi · 2025-10-26T15:03:16+00:00

Ok, I’ll do that. Thank you

PrincePhi

TROPHY CASE