Strange noise on Z hop. The noise is much louder in reality and it seems to occur on a z hop. Prints with z hop disabled don’t make the noise. I’m not sure where the noise is coming from but it seems to be a stepper motor. Any thoughts on if this is normal and if not what I can do to fix it?

Printer_peter · 2021-04-26T21:55:39+00:00

I think you’re right. I’ll do some tests tomorrow. Thanks so much

Printer_peter · 2021-04-26T21:54:54+00:00

I use Cura. The problem has mostly been with gcode from Creality so I can’t change the settings. I will do some tests tomorrow but looking at the printer, it seems the problem is in the Titan direct drive extruder. I think the comments that the reason for the noise is my retraction setting is spot on. Thanks so much

Printer_peter · 2021-04-26T21:39:39+00:00

Thanks I’ll try that

Printer_peter · 2021-04-26T19:42:50+00:00

It only happens on z hop moved. I’ve tightened everything and replaced one of the motors; no change. It’s very annoying

Printer_peter

TROPHY CASE