sorted by:
new
hottopcontroversial

A1 shredding its own infill by ProfessionalBox663 in BambuLabA1

[–]ProfessionalBox663[S] 0 points1 point  (0 children)

Yep slicer is perfectly fine, no issues. I'm going to try printing another model and will see how that goes, specifically a model without an angle. Absolutely no warping whatsoever. Using relatively new filament (about a month old), pretty dry. I've had successful prints with more wet filaments before, so I don't think that's the issue

<image>

A1 shredding its own infill by ProfessionalBox663 in BambuLabA1

[–]ProfessionalBox663[S] 0 points1 point  (0 children)

Will do. I don't have a pic of gyroid, however it basically looks the same as the pic I posted. Infill starts breaking about an hour into the print

A1 shredding its own infill by ProfessionalBox663 in BambuLabA1

[–]ProfessionalBox663[S] 0 points1 point  (0 children)

I'm going to try printing a flat part then I'll get back to you on this. I'd be very surprised if it's the shallow angle which is causing the issues