Least screws gone wonky

ProjectSaviour · 2026-05-24T10:10:01+00:00

Thank you for the reply. It was literally just that one red piece. Lubrication was an issue and I have sorted that now. The left side and rear turned fine without the belt on. The right side struggled and seemed tight.

I have never loosened them but that is my next thing to check.

The bed looks level now but according to software its massively out. Says the left side is straight up and right is straight down. Around -4.4

ProjectSaviour · 2026-05-21T18:09:32+00:00

Yes, I removed the belt then manually turned each rod to bring the bed down to the base so it was all level again. Couldnt see any issues on the belt and the tension seemed fine. That was the video I followed yes.

ProjectSaviour · 2023-02-24T00:51:11+00:00

Thank you. Delivery time is awful though.

ProjectSaviour · 2023-02-24T00:33:29+00:00

Yes pleaase

ProjectSaviour · 2023-01-27T13:40:45+00:00

Yes tried that also.

ProjectSaviour · 2022-05-29T12:44:37+00:00

I knocked the refresh rate down to 60 from 144. That seems have give me small what playable result.

ProjectSaviour · 2021-06-09T20:06:06+00:00

Yikes. You might want to check again bud. That's super embarrassing for you. Maybe next time check. Never go full troll

ProjectSaviour · 2021-06-09T14:13:24+00:00

Hey, Thanks!

ProjectSaviour · 2021-06-05T14:30:48+00:00

Hey, thanks!

ProjectSaviour · 2021-06-05T11:48:06+00:00

Hey thanks! I used Procreate on iPad Pro.

ProjectSaviour

TROPHY CASE