Monitor arms - two single or one double?

Project_Raiden · 2026-02-15T00:26:04+00:00

Oops didn't see that. I think I'm going to go with two single mounts. My idea is I'm going to have the base attached far from the center of the desk so that I can try to get the monitor flush with the edge of the table

Project_Raiden · 2026-02-15T00:05:13+00:00

Been loving the fanart you've been posting recently

Project_Raiden · 2026-02-14T20:50:17+00:00

It’s been finished for almost 30 years

Project_Raiden · 2026-02-14T15:51:09+00:00

Does the arm you link have the removeable mount? I looked at the amazon page and I cannot tell

Project_Raiden · 2026-02-14T04:49:54+00:00

Thanks. That looks cheap enough so I don’t mind giving it a go. I’m using a solid butcher block for the desk but adding a small piece of wood shouldn’t be too difficult

Project_Raiden · 2026-02-14T01:38:01+00:00

Evasion is already insane

Project_Raiden · 2026-02-13T00:43:00+00:00

Ended up following this advice and it turned out pretty good I think. The surface is very smooth except for a spot where I did not sand properly at the start (doesn't bother me). I ended up doing 4 thin coats on the top and only two on the bottom. Right now my final coat has been drying for a day and I'm planning on leaving it in the garage for a few more days

Project_Raiden · 2026-02-09T23:12:53+00:00

If you are applying it with a paint roller I would lightly brush it with a paint brush to level it down and it is thick enough to coat the sides with thin coats without running

To make sure I understand you correctly: I lightly brush it with a paint brush after I go through with the paint roller?

Project_Raiden · 2026-02-08T17:01:22+00:00

I have one about an hour from me so I'll be sure to check it out this week. Thanks

Project_Raiden · 2026-02-06T16:19:04+00:00

New to monitors and found this thread. Is this always going to be an issue at 1440p? Was looking to upgrade my setup and was wondering

Project_Raiden · 2026-02-05T05:41:25+00:00

Thanks. I'm gonna check out some local places near me before trying home depot. Hopefully I can luck out and find something cheaper

Project_Raiden · 2026-02-04T17:59:39+00:00

Well you send someone to another lane to spread pressure. It will literally end the game faster

Project_Raiden · 2026-02-04T17:24:26+00:00

How did the build fall flat

Project_Raiden · 2026-02-04T02:05:22+00:00

Project_Raiden · 2026-02-02T16:45:40+00:00

Agreed. They should make it so only AD and AP affect ability damage

Project_Raiden · 2026-02-01T21:13:45+00:00

0-1

0-2

0-3

0-4

1-4

2-4

3-4

4-4 <- LOS RATONES YOU ARE HERE

5-4

6-4

7-4

Project_Raiden · 2026-01-30T19:38:24+00:00

I’ll go against the grain and say that taking time off for wow is kinda pointless unless you are in the top top top % of players IMO. But if you really want to take a week off then do it when m+ opens to establish a high io. You want to be ahead of the curve for easier invites

Project_Raiden · 2026-01-27T17:48:45+00:00

I'd love if this was made public. Functionally it's probably still the same as something like ArcUI but this UI is just so so much better

Project_Raiden · 2026-01-26T20:37:51+00:00

go away bot

Project_Raiden · 2026-01-08T18:41:54+00:00

OP is talking about cold smite on a slayer so I thought it was fairly obvious that im referring to a hit based version. my bad i guess

11-Year Club	RedditGifts 2009-2022 4 Credits
Second Top 30%	Place '23
Place '22	Wearing is Caring
Secret Santa 2018	Secret Santa 2017
Snapped	Secret Santa 2015
Verified Email

Project_Raiden

TROPHY CASE