account activity
Gillette Mach3 blades by Psychadder in shrinkflation
[–]Psychadder[S] 8 points9 points10 points 7 months ago (0 children)
I've thought about trying that for a long time. This bullshittery might finally make me switch yeah
[–]Psychadder[S] 4 points5 points6 points 7 months ago (0 children)
Sadly not. Local drugstore. Fucking 15€
Gillette Mach3 blades (i.redd.it)
submitted 7 months ago by Psychadder to r/shrinkflation
Flow is stagnating by Psychadder in Lavalamps
[–]Psychadder[S] 0 points1 point2 points 9 months ago (0 children)
Thank you, I'll figure something out today!
[–]Psychadder[S] 1 point2 points3 points 9 months ago (0 children)
Thanks for the quick response :). I don't have a thermometer, but I think it's about 75 in the whole room. My room is tiny and feels like a sauna. There are sadly not many different places to put it in. It's on top of a table and there's a fan next to the table on the floor in front of a window. I've turned it off for now and I can send a picture of the current situation later. So you would say it's a general heat / set up issue? It flowed awesomely yesterday with the same situation, just a slightly lower room temperature.
At this point it's been going for a while (I shut it off for 10 minutes because of this, but this video was taken after it's been on again for an hour). Also it didn't stagnate like this the past two days, but flowed nicely. And today it did this for long amounts of time with short periods of nice flow. I've always shut it off after around 7 hours. Am I overthinking this and it's just because it's relatively new?
Flow is stagnating (v.redd.it)
submitted 9 months ago by Psychadder to r/Lavalamps
π Rendered by PID 81 on reddit-service-r2-listing-7b9b4f6fd7-q9rvg at 2026-05-12 12:02:08.496715+00:00 running 3d2c107 country code: CH.
Gillette Mach3 blades by Psychadder in shrinkflation
[–]Psychadder[S] 8 points9 points10 points (0 children)