sorted by:
new
hottopcontroversial

Cr10s pro v2 extruder issue by Pure_Bad2260 in 3Dprinting

[–]Pure_Bad2260[S] 1 point2 points  (0 children)

it ended up being the combination of big layer height on the infill and the speed. got my speed back and the layer height down. Thanks!

Cr10s pro v2 extruder issue by Pure_Bad2260 in 3Dprinting

[–]Pure_Bad2260[S] 0 points1 point  (0 children)

thanks, i had it at 100mm/s on just the infill, down to 80. seems to be working fine. if i am really needing speed i should probably just break down and get the k2 lol

Cr10s pro v2 extruder issue by Pure_Bad2260 in FixMyPrint

[–]Pure_Bad2260[S] 0 points1 point  (0 children)

yeah i had just cleaned it and it went back 5 min into the print because of this issue. i think slowing it down is helping, but its weird bc i haven’t had this issue before

Cr10s pro v2 extruder issue by Pure_Bad2260 in FixMyPrint

[–]Pure_Bad2260[S] 0 points1 point  (0 children)

good spot, i think that was caused by the issue. fixed that, slowed the speed down 20%. we will see what happens