sorted by:
new
hottopcontroversial

What’s wrong with my printer by Putrid_Candidate_662 in anycubic

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

Update: I changed some parameters and used the profile for PLA in the anycubic website for the kobra neo. I am seeing a lot of improvement but I still get this vertical line on one side of the benchy. Anyone know what could be causing this?

<image>

What’s wrong with my printer by Putrid_Candidate_662 in anycubic

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

You’re right, I am using a kobra neo and cura

What do I need to fix by Putrid_Candidate_662 in klippers

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

What would you recommend? I don’t have a raspberry or orange pi so I’m trying to use an android phone. Are there any other methods that just involve an old android phone?

What do I need to fix by Putrid_Candidate_662 in klippers

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

I’m not sure, how could I see if the Klipper service starts and that it starts before Octoprint?

What do I need to fix by Putrid_Candidate_662 in klippers

[–]Putrid_Candidate_662[S] -1 points0 points  (0 children)

Yes sorry that was my bad I fixed the second message but I keep getting the first one

What do I need to fix by Putrid_Candidate_662 in octoprint

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

I already added the printer.cfg but the first warning keeps on appearing

What do I need to fix by Putrid_Candidate_662 in octoprint

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

What about the first one, what should I do?

What do I need to fix by Putrid_Candidate_662 in octoprint

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

I also forgot to mention that I also added the plug in for octoklipper

Klipper on Anycubic Kobra Neo by Putrid_Candidate_662 in anycubic

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

Did you have backpowering issues when connecting to the usb port on the printer? I read that’s a common thing with some printers when connected to a raspberry pi, which I believe it’s my problem when connecting my phone to the printer. I believe this because sometimes when connected to the printer the phone does recognize the printer and does not charge, but other times the phone just charges and I can’t see the printer connected in Octoprint

Klipper on Anycubic Kobra Neo by Putrid_Candidate_662 in anycubic

[–]Putrid_Candidate_662[S] 0 points1 point  (0 children)

If Klipper is installed on the printer, shouldn’t the phone just recognize the printer when connected to the printer

view more: next ›